Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
Polymer degradation is a change in the properties of a polymer under the influence of one or more environmental factors such as heat, light, humidity or chemicals. These changes may be undesirable, such as changes during use, or desirable, as in biodegradation or deliberately lowering the molecular weight of a polymer…
Abstract Cationic pincer platinum(II) complexes bearing secondary thioamide units showed aggregation‐induced emission (AIE) activity in chloroform/hexane and methanol/water mixtures. Hydrogen bonding of the thioamide units and interionic interactions contributed to the AIE activities.
Lattice defects such as vacancies, voids and dislocations are inevitably present in any material of technological interest. In this work, non-equilibrium molecular dynamics simulations are conducted to investigate how the monatomic vacancies and nanovoids influence the lattice thermal conductivity of silicon. The resu…
Some nonvolatile phase change memory (PCM) cells with 80-nm heating electrodes are found very difficult to RESET at 3 mA, which directly affects the RESET distribution of the PCM. The large crystal grains with hexagonal structure in the active phase change area, discovered by transmission electron microscope, are the…
Quantum-dot-sensitized solar cells are emerging as a promising development of dye-sensitized solar cells, where photostable semiconductor quantum dots replace molecular dyes. Upon photoexcitation of a quantum dot, an electron is transferred to a high-band-gap metal oxide. Swift electron transfer is crucial to ensure a…
Recently great progress has been achieved in highly effective hybrid solar cells fabricated using aqueous materials. The state‐of‐the‐art energy conversion efficiency has been close to 5% with high photocurrent. However, charge separation and transport mechanism in the aqueous‐processed hybrid solar cells are rarely r…
Circular dichroism (CD) spectroscopy is one of the few experimental techniques sensitive to the structural changes that peptides undergo when they adsorb on inorganic material surfaces, a problem of deep significance in medicine, biotechnology, and materials science. Although the theoretical calculation of the CD spec…
Molecular dynamics simulations are applied to investigate salt-free planar polyelectrolyte brushes under poor solvent conditions. Starting above the Θ-point with a homogeneous brush and then gradually reducing the temperature, the polymers initially display a lateral structure formation, forming vertical bundles of ch…
Abstract Metal-organic frameworks (MOFs) represent a novel class of materials that are the subject of intense research efforts due to their potential technological applications. Although major efforts are being pursued in improving their adsorption properties, the use of open shell metal centers can add magnetic prope…
Single-wall carbon nanotubes (SWCNTs) have a variety of potential and demonstrated applications, and their production rates are increasing rapidly. This increase in production has motivated research on their transport and potential transformation and their toxicity in the environment. In this work, we examined the dir…
A tunable lithography-less nanofabrication process using a metal thin-film thermal dewetting technique has been developed to fabricate wafer-scale and uniform plasmonic substrates at low cost for optimal performance in surface enhanced Raman scattering (SERS) applications. The relationship between the tunable paramete…
The spectrum selective absorption effect of a vertically cascaded metal-dielectric grating structure is studied. A polarization-independent spectrum selective absorber based on two pairs of stacked metal-dielectric grating structures is presented for the infrared frequencies. The near-unity absorption with polarizatio…
Drug release from liposomal formulations is governed by a complex interplay of kinetic (i.e., drug permeability) and thermodynamic factors (i.e., drug partitioning to the bilayer surface). Release studies under sink conditions that attempt to mimic physiological conditions are insufficient to decipher these separate c…
In this paper, we report on a continuous-flow microreactor process to prepare ZnO quantum dots (QDs) with widely tunable particle size and photoluminescence emission wavelengths. X-ray diffraction, electron diffraction, UV-vis, photoluminescence and transmission electron microscopy measurements were used to characteri…
The sulfation showed a dual effect on the selective catalytic reduction (SCR) reaction over MnO x /TiO 2 . The activation of adsorbed NH 3 and the adsorption of NO x on MnO x /TiO 2 were both restrained after the sulfation. Therefore, the SCR reaction through the Eley–Rideal mechanism and that through the Langmuir–Hin…
The ceramic precursor for ZrC/SiC was prepared via solution‐based processing using polyzirconoxane, polycarbosilane, and divinylbenzene. The precursor could be transformed into ZrC/SiC ceramic powders at relative low temperature (1500°C). The cross‐linking process of precursor was studied by FT – IR . The conversion f…
Abstract Soybean‐oil‐based cationic polyurethane coatings with antibacterial properties have been prepared with a range of different molar ratios of hydroxyl groups from an amine diol. A second series of polyurethane coatings were prepared from soy polyols with different hydroxyl numbers. All of the cationic PU disper…
Etching or size-focusing methods are now widespread for preparation of atomically monodisperse thiolate-protected gold nanoparticles. Size-focusing methods are not widespread, however, in the production of water-soluble gold nanoparticles. Reported here is a new method for size-focusing of large gold nanoparticles uti…
Zinc oxide nanowires generated by hydrothermal method present superior physical and chemical characteristics. Quality control of the growth has been very challenging and controlled growth is only achievable under very limited conditions using homogeneous seed layers with high temperature processes. Here we show the co…
Generally reversible stimuli-responsive materials do not memorize the stimulus. In this study we describe an example in which stretched and constrained semi-crystalline polymer networks respond to solvent gases with stress and simultaneously memorize the concentration and the chemical nature of the solvent itself in t…