S. ÜNERİ1969-01-01Communications Faculty Of Science University of Ankara Series B Chemistry and Chemical Engineering
Bu çalışma linear polarizasyon metodunun bu günkü durumunu ve bugüne kadar korozyon hızı tayinine uygulanmasını göstermektedir. Bu metodun çok pra¬tik ve faydalı olduğu gösterilmiştir. Metodun genel bir uygulama alanı göstermesi ve uygulanmasının kolay olması büyük bir avantaj sağlamaktadır. Bu metotla ko¬laylıkla kor…
Corrosion Behavior and InhibitionHydrogen embrittlement and corrosion behaviors in metalsMaterial Properties and Failure Mechanisms
Shiro Sato、K oji Nagata1969-01-01Journal of the Japan Institute of Metals and Materials
A study was made on the quench sensitivity of Cu-0.3∼1.5%Cr alloys. The time-temperature-precipitation curve (T-T-P curve) was drawn by plotting the electrical conductivity of specimens which were solution treated and then directly quenched over the temperature range of isothermal heat treatment. The quench sensitivit…
Microstructure and mechanical propertiesMicrostructure and Mechanical Properties of SteelsCopper Interconnects and Reliability
C.C. Shale、J. H. Holden1969-01-01IEEE Transactions on Industry and General Applications
Negative corona onset and sparkover voltages in air are shown to be affected by temperature, density, and the pipe-to-wire ratio of radii when using concentric cylindrical electrodes. Use of large wires at high temperatures demonstrates that onset of electrical discharge occurs at voltages significantly less than thos…
High voltage insulation and dielectric phenomenaLightning and Electromagnetic PhenomenaAerosol Filtration and Electrostatic Precipitation
J. W. Steeds1969-01-01physica status solidi (b)
Abstract Screw, edge, and mixed dislocations are treated by a new method which is simple to handle. Labour saving equations are derived which further shorten the algebraic processes. The results emphasize the need for anisotropic expressions in the case of common cubic materials, and are presented in a form which show…
Microstructure and mechanical propertiesMetallurgy and Material FormingX-ray Diffraction in Crystallography
A. A. Vol'Fson、V. K. Subashiev1969-01-01physica status solidi (b)
Abstract The effect of heavy doping on the reflection spectra of silicon and germanium is investigated by measuring the fractional change in reflectance, Δ R / R , between pure and doped materials. This effect arises from the narrowing of the forbidden gap in heavily doped materials. The form of the Δ R / R spectrum a…
Thin-Film Transistor TechnologiesSilicon Nanostructures and PhotoluminescenceSemiconductor materials and interfaces
C. A. Evans、Michael J. Taylor1969-01-01Journal of the Chemical Society A Inorganic Physical Theoretical
Low-frequency i.r. and Raman spectra of InCl3,2Et2O, InBr3,2Et2O, InCl3,2Et2S, and InBr3,2Et2S are given and interpreted in terms of D3h skeletal symmetry.
Crystal structures of chemical compoundsSolid-state spectroscopy and crystallographyChemical Thermodynamics and Molecular Structure
S. P. Taneja1969-01-01physica status solidi (b)
Abstract Principal magnetic susceptibilities of single crystal of dysprosium ethylsulfate have been computed in the temperature range of liquid‐nitrogen to room temperature, assuming that the crystal field has C 3h symmetry around the Dy 3+ ion. It is observed that magnetic anisotropy increases with the decrease of te…
Advanced NMR Techniques and ApplicationsSolid-state spectroscopy and crystallographyMolecular spectroscopy and chirality
D. Hinz、P. Paufler、G. E. R. Schulze1969-01-01physica status solidi (b)
Abstract From temperature change experiments (between 260 and 435°C) during secondary creep of the intermetallic compound MgZn 2 an activation enthalpy Δ H = (2.25 ± 0.20) eV for basal slip has been derived. The shear strain rate γ can best be described by the empirical relation γ = 7 × 10 11 s −1 × τ 5.5 ± 1.0 exp (‐…
Magnesium Alloys: Properties and ApplicationsRare-earth and actinide compoundsAluminum Alloys Composites Properties
Sérgio H. Faria、Domenico Palumbo1969-01-01Journal of The Electrochemical Society
Abstract not Available.
Luminescence Properties of Advanced MaterialsSolid State Laser Technologies
Shin Takeuchi1969-01-01鐵と鋼 : 日本鐡鋼協會々誌
1Fe-Mo,
Microstructure and Mechanical Properties of SteelsMetal Alloys Wear and PropertiesMaterial Properties and Failure Mechanisms
J. Bernard Gill、Sara Riaz1969-01-01Journal of the Chemical Society A Inorganic Physical Theoretical
Controlled hydrolytic degradation of ultraphosphate glasses at their branching sites has indicated that these compounds, with a ratio of univalent-cation to phosphorus between 0·7–1·0, consist of random arrangements of trimetaphosphate rings, polyphosphate chains, and branched chains. No ring structures larger than tr…
Glass properties and applicationsFlame retardant materials and propertiesPigment Synthesis and Properties
W. Schülke、U.E.P. Berg、O. Brümmer1969-01-01physica status solidi (b)
Abstract The effect of Coulomb interaction on the Compton scattering cross‐section (CSCS) of a free electron gas has been calculated theoretically by Ohmura and Matsudaira within the framework of the random phase approximation (RPA). These calculations have shown that plasmon emission during the scattering process dim…
Advanced Chemical Physics StudiesX-ray Spectroscopy and Fluorescence AnalysisElectron and X-Ray Spectroscopy Techniques
Shōtaro Morozumi、Nobuo Tsuno、Shigeyasu Koda1969-01-01Transactions of the Japan Institute of Metals
Hardness measurements and microscopic observations by both optical and transmission electron microscopy were carried out mainly on a beryllium-3wt% iron alloy.The alloy was solution-treated at 1150°C, followed by oil-quenching, and aged at 400° to 700°C for a various time. In the quenched specimens, helices and loops…
Fusion materials and technologiesIntermetallics and Advanced Alloy PropertiesNuclear Materials and Properties
Chung-Chiun Liu、John C. Angus1969-01-01Journal of The Electrochemical Society
The bismuth‐tellurium alloy system was investigated by electromotive force measurements, coulometric titrations, x‐ray diffraction, and differential thermal analyses. The thermodynamic properties of the system have been obtained from the electromotive force measurements. The partial molar free energy, enthalpy, and en…
Advanced Thermoelectric Materials and DevicesIntermetallics and Advanced Alloy PropertiesThermodynamic and Structural Properties of Metals and Alloys
J. C. Williams、Rodney R. Boyer、M. J. Blackburn1969-01-01OpenAlex
A survey is presented of the fracture topography observed in titanium and titanium alloys. Ductile fracture by microvoid nucleation, growth, and coalescence is of widespread occurrence in these alloys. It is usually possible to qualitatively relate the dimple size to the macroscopic ductility of the alloy. Titanium al…
Hydrogen embrittlement and corrosion behaviors in metalsTitanium Alloys Microstructure and PropertiesAdvanced materials and composites
Hiroshi Kubota、Yoko Yamanaka、I. G. Dalla Lana1969-01-01JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
It was illustratively shown that the use of a definition of the effective diffusivity for a multi -component gaseous reaction system easily gives a sufficiently accurate approximate solution for diffusion through a stagnant gas film. In order to apply the same idea for approximate estimation of the effectiveness facto…
Catalytic Processes in Materials ScienceCatalysts for Methane ReformingCatalysis and Hydrodesulfurization Studies
C. B. Davies、Emma Mitchell1969-01-01Philosophical magazine
After fast electron irradiation at 80°K graphite exhibits, in its electrical resistivitiy during isochronal annealing, a reverse stage followed by normal stages. These constitute the Austerman and Hove peak. The reverse stage has previously been attributed to the separation of close Frenkel pairs of defects. In the pr…
Nuclear Physics and ApplicationsGraphite, nuclear technology, radiation studiesNuclear and radioactivity studies
J GOODMAN、J. A. Gliksman1969-01-01OpenAlex
Boron filament-epoxy composite tubes were evaluated for use as long column members in a spacecraft. Struts, 8 ft long and 3.2 in. in diameter, were designed, fabricated, and tested. After evaluation of test results, three-ply and four-ply laminates were selected to satisfy design load requirements of 5000 and 7000 lb.…
Structural Behavior of Reinforced ConcreteHigh-Velocity Impact and Material Behavior
Hendrik J. Hageman、W. G. B. Huysmans1969-01-01Journal of the Chemical Society D Chemical Communications
Irradiation of 2,6-diphenyl-p-benzoquinone in benzene gives a dimer whose precise structure is unknown, while irradiation in acetonitrile gives 2-hydroxy-4-phenyldibenzofuran.
Photochromic and Fluorescence ChemistryOxidative Organic Chemistry ReactionsOrganic Chemistry Cycloaddition Reactions
R. Cadoret、P. Delavignette1969-01-01physica status solidi (b)
Abstract L'étude du contraste a été effectuée en prenant comme modèle le mécanisme de décomposition spinoïdale prévu par Cahn [1 à 3] pour un alliage binaire cubique, dont l'énergie élastique est minimum suivant une direction β parallèle à <100>. Les contrastes effectivement observés au microscope électronique s…
Solidification and crystal growth phenomenananoparticles nucleation surface interactionsAdvanced Materials Characterization Techniques