Dillon M. Brown、C. Holt、J.E. Thompson1965-01-01Proceedings of the Institution of Electrical Engineers
The effect of both compressive and tensile stresses of up to 500lbf/in2 at various temperatures in the range 20–400°C on the power loss, coercive force and remanence of two grades of grain-oriented 3% silicon iron has been measured at 50c/s. Increasing tension at first reduces the power loss and the coercive force, bu…
Microstructure and Mechanical Properties of SteelsMagnetic Properties and ApplicationsPower Transformer Diagnostics and Insulation
John R. Lewis1965-01-01Plastic & Reconstructive Surgery
WITH SPECIAL REFERENCE TO ALLOPLASTIC MATERIALS Atlanta, Georgia 478 Peachtree Street, N. E. Atlanta, Georgia
Material Selection and PropertiesConstruction Engineering and SafetyEngineering and Material Science Research
Zongjin Li、R. E. Reed-Hill1965-01-01OpenAlex
Internal deformation and fracture of second order /1011/-/1012/ twins in Mg single crystals, noting large strains
Magnesium Alloys: Properties and ApplicationsBoron and Carbon Nanomaterials ResearchMagnetic Properties of Alloys
J.L. Bates1965-01-01Nuclear Science and Engineering
The absorption spectra for single crystal and polyerystalline UO2 have been measured between 0.6 and 15 μm at room temperature. The spectrum for UO2 resembles that of a typical semiconductor, opaque in the visible but transparent over a large portion of the infrared. An absorption edge is located at approximately 0.6…
Nuclear Materials and Properties
Earl M. Otto1965-01-01Journal of The Electrochemical Society
Oxygen pressures of the pyrolusite form of MnO 2 have been determined in a temperature range of 441°–642°C. The dissociation reaction 4 MnO 2 ( c ) ⇄ 2 Mn 2 O 3 ( c ) + O 2 ( g ) has been found to reach a steady state in the forward direction; reaction in the reverse direction was exceedingly slow and did not reach a…
Energetic Materials and CombustionThermal and Kinetic AnalysisChemical Thermodynamics and Molecular Structure
T. M. Connor、D. J. Blears、G. R. Allen1965-01-01Transactions of the Faraday Society
T. M. Connor, D. J. Blears and G. Allen, Trans. Faraday Soc., 1965, 61, 1097 DOI: 10.1039/TF9656101097
High voltage insulation and dielectric phenomenaOrganic Light-Emitting Diodes ResearchConducting polymers and applications
H. Ti Tien1965-01-01The Journal of Physical Chemistry
ADVERTISEMENT RETURN TO ISSUEPREVArticleInteraction of Alkali Metal Cations with Silica Gel1H. Ti TienCite this: J. Phys. Chem. 1965, 69, 1, 350–352Publication Date (Print):January 1, 1965Publication History Published online1 May 2002Published inissue 1 January 1965https://pubs.acs.org/doi/10.1021/j100885a508https://d…
Mesoporous Materials and CatalysisAdsorption, diffusion, and thermodynamic properties of materials
Masanori Akazaki1965-01-01IEEE Transactions on Power Apparatus and Systems
The effect of high direct voltage on the formation and dislodging of water drops hanging from a smooth conductor will be shown and used to explain the resulting corona characteristics, such as pulse amplitude and repetition rate, audible noise, radio influence (RI) and loss current, and corona current waveforms. Pheno…
High voltage insulation and dielectric phenomenaPower Transformer Diagnostics and InsulationAerosol Filtration and Electrostatic Precipitation
T. Mura1965-01-01physica status solidi (b)
Abstract Mises' yield criterion, the Prandtl‐Reuss relation between stress and plastic strain rate, and Hencky's theorem on shear lines for isotropic elastic‐plastic materials are derived from the theory of continuous distributions of dislocations. A linear relation between the velocity of dislocations and the gliding…
Microstructure and mechanical propertiesMetal Forming Simulation TechniquesHigh-Velocity Impact and Material Behavior
John V. Sharp、M. J. Makin、J. W. Christian1965-01-01physica status solidi (b)
Abstract The dislocation structure produced by tensile deformation of magnesium single crystals at 77 K and at room temperature has been investigated by transmission electron microscopy techniques. Sections both parallel and perpendicular to the basal plane have been cut by spark machining from single crystals deforme…
Microstructure and mechanical propertiesMagnesium Alloys: Properties and ApplicationsAluminum Alloy Microstructure Properties
Stephen Brunauer1965-01-01Pure and Applied Chemistry
Abstract
Surface Modification and SuperhydrophobicityMaterial Selection and Properties
Ryo Horiuchi、Hideo Yoshinaga、Shingo HAMA1965-01-01Transactions of the Japan Institute of Metals
A new type yielding phenomenon was observed in Al-Mg and Al-Cu alloys which were pulled at high temperatures above about 350°C. In order to determine characteristics of this high temperature yielding phenomenon, several binary aluminium alloys were investigated by tensile tests at various temperatures from room temper…
Microstructure and mechanical propertiesMetallurgy and Material FormingHigh-Velocity Impact and Material Behavior
M. M. Faktor、J. I. Carasso1965-01-01Journal of The Electrochemical Society
The thermodynamic stability of tetragonal germanium dioxide has been characterized by measurements of the equilibrium ratios in the temperature range 830°–1020°K. Results are extrapolated to 298°K using estimated heat capacities, to give the standard thermal parameters, and to the tetragonal‐hexagonal transition point…
Advanced ceramic materials synthesisGlass properties and applicationsSilicon Nanostructures and Photoluminescence
G. Metzger、P. Pluvinage、R. Torguet1965-01-01Annales de Physique
Les calculs de l’effet Kerr magnéto-optique des substances isotropes sont effectués jusqu’aux termes proportionnels au carré du paramètre Q de Voigt. Dans le cas du fer, la correction à apporter à l’approximation linéaire est de l’ordre de quelques secondes d’arc. Quelques graphiques illustrent les principaux résultat…
Magnetism in coordination complexesIron oxide chemistry and applicationsMagneto-Optical Properties and Applications
W. G. Perkins、G. A. Crosby1965-01-01The Journal of Chemical Physics
Optical absorption and emission spectra of trivalent ytterbium in various chelates are reported. The experimental energy levels of Yb3+ are compared with predictions of electrostatic crystal-field theory and of a contact model of ligand-field theory. Good agreement is found between theory and experiment for the electr…
Luminescence Properties of Advanced MaterialsRadioactive element chemistry and processingLanthanide and Transition Metal Complexes
Ryong‐Joon Roe1965-01-01Proceedings of the National Academy of Sciences
Proceedings of the National Academy of Sciences (PNAS), a peer reviewed journal of the National Academy of Sciences (NAS) - an authoritative source of high-impact, original research that broadly spans the biological, physical, and social sciences.
Material Properties and ApplicationsAdvanced Theoretical and Applied Studies in Material Sciences and GeometryAdsorption, diffusion, and thermodynamic properties of materials
H. M. Otte、A. G. Crocker1965-01-01physica status solidi (b)
Abstract For structures with hexagonal symmetry, three different axial systems (rhombohedral, orthorhombic, and hexagonal) are in general use to define the indices of directions and planes. The hexagonal axial system is the one in which confusion is most likely to occur if the axes and the notation are not clearly def…
Mesoporous Materials and CatalysisQuasicrystal Structures and PropertiesX-ray Diffraction in Crystallography
G. Paolini、M. Masoero、Francesca Sacchi 等 4 位作者1965-01-01Journal of The Electrochemical Society
Results of BET adsorption measurements on a‐c and d‐c sulfuric acid anodic films on aluminum have been compared with results of pore counts and with coating ratio figures. Both real surface and volume were measured. A roughness factor should be introduced in order to obtain an agreement between data from different sou…
Concrete Corrosion and DurabilityAnodic Oxide Films and NanostructuresSurface Roughness and Optical Measurements
John McKeown1965-01-01Proceedings of the Institution of Electrical Engineers
A technique has been developed to measure the 60c/s a.c. intrinsic electric strength of organic polymers. This technique consists in embedding the electrodes and film to be measured in a thermoset resin. The solid construction eliminates prebreakdown discharges on the film surface from the breakdown of liquid used in…
High voltage insulation and dielectric phenomenaPower Transformer Diagnostics and InsulationElectrostatic Discharge in Electronics
Norman S. Anderson、Aled Rees1965-01-01Journal of the Chemical Society (Resumed)
N. S. Anderson and D. A. Rees, J. Chem. Soc., 1965, 5880 DOI: 10.1039/JR9650005880
Diatoms and Algae Research