Andrew J. Grant、T M Griffiths、G. D. Pitt 等 4 位作者1975-01-07Journal of Physics C Solid State Physics
Room-temperature electrical resistivity and Hall effect measurements as a function of pressure are reported on p-type MoS 2 and on n-type MoS 2 , MoSe 2 and MoTe 2 . In each case, the resistivity decreases under pressure, due to an increase in the carrier concentration. The Hall mobility is relatively pressure-indepen…
2D Materials and ApplicationsChalcogenide Semiconductor Thin FilmsMXene and MAX Phase Materials
J. L. den Otter、J.B. Schijf、J. L. S. Wales 等 4 位作者1975-01-01Steinkopff eBooks
PVC is a very versatile thermoplastic. Unfortunately, its potentialities often cannot be realized in practice because of the difficulties encountered in processing. For instance, successful extrusion is possible only in a limited range of conditions and with the use of processing aids. If processing temperatures and s…
Rheology and Fluid Dynamics StudiesPolymer Science and PVC
Takeshi Taguchi1975-01-01NIPPON SUISAN GAKKAISHI
To clarify the internal corrosion mechanism in food cans, the effect of trimethylamine oxide (TMAO) on the liberation of tin from tinplate was examined. In the range of pH 2.8-8.0, tin liberation by TMAO was maximum around pH 4, at which there was also marked decomposition of TMAO. Around that pH, the amount of tin li…
Corrosion Behavior and InhibitionNanocomposite Films for Food Packaging
Norio Isoda、Yotaro Kobayashi、Tetsumi Horikoshi 等 4 位作者1975-01-01Transactions of the Architectural Institute of Japan
Environmental Condition : Air Temperature (23.5±0.5℃) and Relative Humidity (50±10%) were kept constant in a circulation type wind tunnel. Surface temperatures of inside wall, ceiling and floor were kept almost equal to air temperature. Air velocity was the only variable with <10cm/s, 30cm/s, and 50cm/s. Subjects were…
Thermoregulation and physiological responsesTextile materials and evaluationsInfrared Thermography in Medicine
Shigeo Okuda、H. Mizubayashi1975-01-01Radiation Effects
During irradiation, some of the mobile point defects induced by irradiation migrate to and pin down dislocations. Whereas a behavior of these pinning points on dislocations is subject to controversy at present,1, 2 the number of these pinning points is considered to increase, at least, during irradiation. Normally, si…
Microstructure and mechanical propertiesUltrasonics and Acoustic Wave PropagationHigh-Velocity Impact and Material Behavior
Kazuyoshi Kamachi、Mutsumi Touge1975-01-01Corrosion engineering digest
The phenomena induced in austenitic stainless steels by cathodic charge of hydrogen were phase transformation, hydride and numerous surface cracks formation as previously reported. In this study, the hydrogen induced phases were compared with those of quench or stress induced, and the hydrides were compared with those…
Microstructure and Mechanical Properties of SteelsHydrogen embrittlement and corrosion behaviors in metalsWelding Techniques and Residual Stresses
Wolfgang Hackbusch、H. Rupp、Karl Wieghardt1975-01-01Journal of the Chemical Society Dalton Transactions
59 Co N.m.r. spectra of 24 µ-carboxylato-di-µ-hydroxo-bis[triamminecobalt(III)] complexes have been examined. Chemical-shift values are constant for all the complexes. However, the linewidths differ significantly. It is shown that the 59Co relaxation is a function of the basicity of the oxygen atoms of the symmetrical…
Magnetism in coordination complexesPorphyrin and Phthalocyanine ChemistryLanthanide and Transition Metal Complexes
Raymond P. Goehner1975-01-01Advances in X-ray Analysis
Computer simulation of back reflection Laue patterns now provides the means to plot Laue patterns for any crystal system in any orientation. This capability makes it possible to determine, rapidly and accurately, the orientation of single crystals and large grains in polycrystalline materials even in cases where littl…
Microstructure and Mechanical Properties of SteelsAdvanced X-ray Imaging TechniquesX-ray Diffraction in Crystallography
Kazuo Hosokawa1975-01-01Journal of the Japan Institute of Metals and Materials
With the aim of obtaining a siliconized layer without any porosity, a silico-carburizing method using a hot bath consisting of Si, carbonate (K2CO3, Na2CO3, Li2CO3, SrCO3 or BaCO3) and neutral salts (KCl, NaCl) has been studied. The results obtained are summarized as follows.(1) In a hot bath consisting of neutral sal…
Advanced ceramic materials synthesis
Katsuhiro Kuroda、Tatsuro Suzuki1975-01-01Journal of Applied Physics
The current efficiency of the lens system for an accelerating lens composed of three anodes combined with an auxiliary magnetic lens in a field emission scanning electron microscope is described. In this system the spot size for the needed primary beam current can satisfactorily be minimized since the working distance…
Advanced Electron Microscopy Techniques and ApplicationsAdvancements in Photolithography TechniquesElectron and X-Ray Spectroscopy Techniques
Kunio Shiobara1975-01-01Corrosion engineering digest
Anodic polarization behaviours of SUS 304 and SUS 316 stainless steel open surface and those of crevice-containing specimen were studied in 0.5M NaCl, NaBr, and NaI solution at 25°C. The results obtained were summarized as follows. The crevice corrosion potentials or the pitting potentials of the crevice-containing sp…
Corrosion Behavior and InhibitionHydrogen embrittlement and corrosion behaviors in metalsHigh Temperature Alloys and Creep
Toshiro Sasaki、Katsuaki Kuroda1975-01-01Journal of the Textile Machinery Society of Japan
No method has so far been established for evaluating the yarn knittability before knitting. Thus, any yarn defective in knittability cannot be found out until it is actually knitted. As an aid to solve this problem, we investigated various methods for evaluating the yarn knittability and obtained the following conclus…
Textile materials and evaluations
A.H. Fahmy、E.L. Adler1975-01-01Proceedings of the Institution of Electrical Engineers
The program package described in the paper performs the transformation of the stiffness, piezoelectric and permittivity (or conductivity) matrices of an anisotropic material under a rotation of the co-ordinate system.
Engineering Technology and MethodologiesMaterial Properties and ApplicationsMechanical and Thermal Properties Analysis
E. O. McLean1975-01-01Communications in Soil Science and Plant Analysis
Calcium is a member of the Alkaline Earth Family, members of which have atoms with well‐shielded nucleii and two valence electrons which are readily lost thereby forming divalent cations. The basic cation, Ca++, neutralizes acids, is essential for plants, and acts as a flocculator and precursor of granular structure o…
Soil Carbon and Nitrogen DynamicsPlant Micronutrient Interactions and EffectsClay minerals and soil interactions
George T. Shiau、J.L. Walter、Stanley S. T. King1975-01-01Spectroscopy Letters
Polarized low-frequency Raman spectra of imidazole single crystals were measured with a He-Ne laser source. A new band at 172 cm−1 (Bg) was observed. An assignment for the lattice vibrations of imidazole crystals is proposed on the bases of this Raman data and far-infrared spectral data of Perchard and Novak, as well…
Crystallography and molecular interactionsSpectroscopy and Quantum Chemical StudiesSolid-state spectroscopy and crystallography
E W Thiele1975-01-01OpenAlex
This paper highlights new prototype development work using copper-nickel alloys for vessel hulls and seawater intake piping systems. Initially, maintenance-free performance and economies that can be realized through the use of copper-nickel alloys in salt water environments are described. Data presented shows performa…
Corrosion Behavior and InhibitionMaterial Selection and PropertiesMaterial Properties and Applications
R. C. Mehrotra1975-01-01Pure and Applied Chemistry
Abstract
Glass properties and applicationsMaterial Properties and ApplicationsMaterial Science and Thermodynamics
Shigeo Hasebe、Yoshiaki Kawaguchi1975-01-01鐵と鋼 : 日本鐡鋼協會々誌
Brittle fracture propagation-arrest characteristics of low C-Mn steel plates containing 0-5%Ni have been investigated by newly developed Tapered Double Cantilever Beam Test, which is a small size test having good correlation to large size Double Tension Test. The results obtained are as follows:1) Brittle fracture pro…
Metal and Thin Film MechanicsHigh-Velocity Impact and Material BehaviorMechanical stress and fatigue analysis
Kunio Nakamura1975-01-01Journal of Polymer Science Polymer Physics Edition
Abstract The complex compliance in extension of gels of poly(vinyl chloride) (PVC) in di(2‐ethylhexyl) phthalate (DOP) and in tricresyl phosphate (TCP) was measured over the frequency range from 0.6 to 0.006 cps and the temperature range from −66 to 65°C: the weight fractions of DOP and TCP in the gels were 0.32, 0.40…
Polymer crystallization and propertiesPolymer Nanocomposites and PropertiesPolymer Science and PVC
R. Bakule、A. Havránek1975-01-01Journal of Polymer Science Polymer Symposia
Abstract The dielectric properties of natural rubber, synthetic polyisoprene, and polybutadiene samples crosslinked with sulfur and of natural rubber samples crosslinked simultaneously with sulfur and dicumyl peroxide were studied. In the investigated systems, the number of polar groups in unit volume and the crosslin…
Advanced Fiber Optic SensorsPolymer Nanocomposites and PropertiesHigh voltage insulation and dielectric phenomena