Moisture and Mechanical Behavior of Wood
とな るが, 1)
Materials Literature
文献浏览
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
Solid-State Reaction between Alumina and Cobalt Oxide
In the preparation of impregnated catalyst composed of alumina carrier and cobalt salt the mixture of alumina or alumina hydrate and cobalt salt is calcined at the temperature between 500°and 800°C. From the theoretical and practical viewpoints it is important to clarify the state of cobalt compounds in the prepared c…
Studies on rare-earth compounds. Part I. The magnetic anisotropy of and crystal field in cerous magnesium nitrate, Ce2Mg3(NO3)12,24H2O
The average magnetic susceptibility and magnetic anisotropy of cerous magnesium nitrate over the temperature range 80–300 K are reported. These results, together with the previously reported g-values, have been interpreted in terms of a point-charge crystal-field model with the inclusion of an orbital reduction parame…
Low Temperature Invar Anomalies in Fe[Single Bond]Ni[Single Bond]Co Alloys
The temperature and magnetic field dependence of the thermal expansion and forced magnetostriction of one cold worked and three annealed Fe–Ni–Co alloy samples has been measured at low temperatures. Sample A (Fe‐34% Ni‐8% Co annealed) and sample D (Fe‐39% Ni‐10% Co cold worked) had large forced magnetostrictions and l…
Stacking Fault Energies in a Cu-Al Alloys
Extended dislocation nodes in αCu-Al solid solution were observed by a transmission electron microscope, and stacking fault energies (SFE) were determined. The specimens were annealed at 700°C after deformation to eliminate the effect of the solute impedance force pinning partial dislocation. Firstly, the variation in…
One-step synthesis of cis-5,6-dideuterio-cis-cyclo-octene and its thermal stability towards concerted, intramolecular transfer of hydrogen
cis-5,6-Dideuterio-cis-cyclo-octene has been synthesised in one step from cyclo-octa-1,5-diene by reduction with dideuteriodi-imide. On prolonged pyrolysis at 250°, intramolecular transfer of the vicinal 5- and 6-protons to the double bond does not occur; thus no 1,2-dideuterio-cis-cyclo-octene is formed.
Grain-Boundary Fragility and Segregation
Intergranular embrittlement induced by equilibrium segregation of solutes is now recognized in a number of engineering alloys, particularly in ferrous systems. In such multicomponent systems, grain-boundary segregation effects can be quite complex, with competitive interactions among a number of surface-active species…
Decorative Electrodeposited Metallic Coatings
Electrodeposition of metallic coatings for decorative purposes is such an extensive topic that it is intended to review in detail only the most important metals. Some indication of types of plating solutions and general formulations is given, but voluminous patent literature exists on this subject. The physical and me…
Low Temperature Catalytic Heaters
Platinum group metal catalysts are incorporated in the Cataheat flameless combustion systems designed by Matthey Bishop to burn hydrocarbon fuels. These systems are safer and more efficient than radiant heaters with an open flame. They are used in portable heaters for a wide range of agricultural, industrial and recre…
THE HOMOGENIZING PROCESS IN HIGH VISCOSITY MATERIALS HAVING DIFFERENT VISCOSITIES
This paper deals with an examination of the hypothesis for striation thickness by Mohr. The effect of viscosity ratio on striation thickness is examined in a cone rotor-type mixer as a uniform shear system, and it is concluded that the effect of the viscosity ratio might be negligible in a system where a minor compone…
An EPR study of an S = 3/2 defect in CaWO4
Abstract After n‐irradiation of CaWO 4 up to a dose of 3 × 10 19 nvt a spectrum consisting of 12 narrow lines is observed. The angular variation of the spectrum shows that a centre with S = 3/2 located at four magnetically inequivalent sites in the structure is involved. The data are consistent with a spin Hamiltonian…
Cooperative Measurement of the Thermal Expansion Behavior of Different Materials up to 1000°C by Pushrod Dilatometers
As a part of a major AGARD project concerning thermophysical properties of solid materials at high temperatures, cooperative thermal expansion measurements up to 1000°C were carried out using pushrod techniques. Sixteen laboratories have contributed results. Parallel samples having the same history were used for all t…
Desenvolvimento larvário de Balanídeos em laboratório - Balanus amphitrite (Var. amphitrite)
É descrita a técnicade criação de balanus amphitrite var. amphitrite em laboratório, sob condições controladas, que permitem observações das mudas, do número de estágios e, ainda são apresentadas as características de cada estágio. Balanus amphitrite amphitrite é criado pela primeira vez em laboratório com sucesso. Do…
Magnetic and Electric Properties of Iron-Silicon Alloys
The physical properties, i.e. magnetostriction, magnetization, electrical resistivity and density, of Fe-Si alloys in the composition range of 0～24% Si, were studied with regard to the effects of two kinds of thermal treatments, viz. the furnace cooling and the water quenching, both after annealing at 1100℃ for 2 hour…
Viscosity Measurement of Liquid Lead-Tin Alloys by the Oscillating Crucible Method
Viscosity of liquid Pb-Sn alloys has been measured by the oscillating crucible method in the temperature ranges from the liquidus to about 800°C. By a careful experiment, it has been possible to obtain results which are accurate to within ±1.0 pct. The variation of viscosity with temperature followed the Arrhenius-typ…
A Fundamental Study of Titanium Deoxidation of Steel
Liquid iron-titanium-oxygen equilibria has been established by equilibrium measurements between liquid iron-titanium alloys and synthesized titanium oxide crucibles and by the thermodynamic data reported previously by the authors.The results obtained are summerized as follows:1) It has been shown to be necessary to co…
Far infrared reflectivity of Cdas2
Abstract Far infrared reflectivity of Cdas 2 bulk crystals in polarized light has been measured at room and liquid‐nitrogen temperature in the 30 to 400 cm −1 frequency range. It is shown that the model of classical non‐interacting oscillators represents the experimental curves adequately. The results are in agreement…
Charge density in a conducting medium
It is well-known that no permanent distribution of free charge can exist in a conductor. A common development of a "relaxation time" concludes that a charge distribution imposed in a conductor will decay exponentially with a time constant ε/σ. This development utilizes Ohm's law, J = σE, with σ constant, which is inap…
Development of texture and structure in Zr-2.5 wt% Nb extruded tubes
Factors which affect the texture and microstructure of Zr-2.5 wt % Nb extruded tubes have been investigated. The major factor that determines th~ texture is the way the metal flows, which is controlled by the die shape, the extrusion ratio and the lubricant. The microstructure is controlled by the temperature during e…
ULTRASONIC MODULI OF ASPHALT CONCRETE
THERE HAS BEEN A NEED FOR A NONDESTRUCTIVE, DYNAMIC TECHNIQUE FOR EVALUATING CERTAIN ELASTIC CONSTANTS OF ASPHALT PAVING MATERIALS. IN THIS STUDY, A METHOD IS DEVELOPED BY WHICH THE DYNAMIC E-MODULUS, G-MODULUS, AND POISSON'S RATIO OF COMPACTED ASPHALT- AGGREGATE SPECIMENS ARE DETERMINED FROM MEASUREMENT OF THE PROPAG…