Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
Phase transformation from β-BiNbO4 to α-BiNbO4 in BiNbO4 bulk samples was studied. From x-ray diffraction patterns, the transformation from β to α phase of BiNbO4 could be observed by heating the bulk samples of β-BiNbO4 from low temperatures to 700–1030°C. Such a transformation did not occur in powder samples and in…
Abstract Fundamental principles of polymer physics were used for description of relaxation behavior of polymer chain near solid surface. In a nanocomposite, considerable portion of polymer matrix is in contact with the filler surface even at very low filler loadings. In this study, nanocomposite was considered as a tw…
There are six known phases for phosphorus at room temperature under high pressure. Only the structure of phase IV, which exists from 107 GPa to 137 GPa, remains unsolved. We performed a powder x-ray diffraction experiment and a Rietveld analysis and successfully determined its structure to be an incommensurately modul…
A special mechanism of strain hardening in deformed nanocrystalline materials (NCMs) is suggested and theoretically described. The mechanism represents generation of disclination dipoles at grain boundaries (GBs) due to GB sliding. It is shown that special strain hardening can effectively suppress plastic flow instabi…
Tungsten oxide W18O49 nanowires with diameters of 10–20nm were synthesized with high yield by thermal evaporation in a tube furnace. By heating tungsten trioxide powder at 900°C in vacuum (5×10−3torr), W18O49 nanowires with diameters of 10–20nm and lengths up to micrometers were produced with high yield on the Au-coat…
The authors report electrical transport properties of p-n junction based on semiconducting single-walled carbon nanotubes (SWCNTs). The formation of p-n junction is realized in SWCNTs, which are encapsulated with Fe nanoparticles at low filling fractions. The devices exhibit an excellent rectifying behavior, and no cu…
A two-step method was proposed in synthesizing V2O5 nanorods on planar substrates, i.e., depositing a V2O3 thin film at approximately 220 degrees C (by heating a pure sheet of vanadium in a rough vacuum) and then heating it in air at approximately 400 degrees C. The V2O5 nanorods produced by this technique are single…
High quality single-crystal CdS nanowire (NW) networks have been synthesized on Si(111) substrates via the chemical vapour deposition method. X-ray diffraction and selected area electron diffraction show that the NWs in the networks grow along the directions and their (0001) crystal planes are parallel to the Si(111)…
Enhanced ultraviolet (UV) photoresponse is observed in rf magnetron sputtered ZnO thin films interfaced with ultrathin overlayers of different metals (Al, Cu, Sn, Pb, Au, and Te). Electrons transferred from a metal layer to the semiconductor at the interface compensate the surface states and increase the dark conducti…
Epitaxial growth of (0001)-oriented BiFeO3 thin films on the (0001) surface of GaN has been realized using intervening epitaxial (111) SrTiO3∕(100) TiO2 buffer layers. The epitaxial BiFeO3 thin films have two in-plane orientations: [112¯0]BiFeO3‖[112¯0]GaN plus a twin variant related by a 180° in-plane rotation. BiFeO…
We show that one may view the self-part and the distinct-part of the van Hove dynamic correlation function of a simple fluid as the one-body density distributions of a binary mixture that evolve in time according to dynamical density functional theory. For a test case of soft-core Brownian particles the theory yields…
Many materials weaken through fracturing when subjected to extreme stresses. By contrast, we show that breaking down repulsive bits of matter dispersed in a viscous liquid can cause a dramatic and irreversible increase in the dispersion's elasticity. Anionically stabilized microscale emulsions subjected to a history o…
Sn O 2 : Eu 3 + nanoparticles uniformly dispersed in TiO2 matrix were prepared at 185°C in ethylene glycol. Unlike in SnO2:Eu3+, significant improvement in the exciton mediated energy transfer between SnO2 and Eu3+ ions was observed when SnO2:Eu3+ nanoparticles are dispersed in TiO2 matrix, and this is attributed to e…
Mechanical stress is a decisive factor for the differentiation, proliferation, and general behavior of cells. However, the specific signaling of mechanotransduction is not fully understood. One basic problem is the clear distinction between the different extracellular matrix (ECM) constituents that participate in cell…
Changes in the electronic structures of Ge2Sb2Te5 (GST) and N-doped Ge2Sb2Te5 film during the phase transition from an amorphous to a crystalline phase were studied using synchrotron radiation high-resolution x-ray photoemission spectroscopy. The changes in tetrahedral and octahedral coordinated Ge 3d peaks are closel…
The authors synthesized polymeric nitrogen at pressures above 110GPa with laser heating above 2000K. To prove its cubic gauche (cg) structure, the authors have grown single crystals which produced strong reflections at large diffraction angles. The authors found nine peaks in the 2Θ=35° range with a special diamond an…
The geometrical structures and field emission properties of pristine and N-doped capped (5,5) single-walled carbon nanotubes have been investigated using first-principles density-functional theory. The structures of N-doped carbon nanotubes are stable under field emission conditions. The calculated work function of N-…
A versatile simulation method for modeling percolation in nanocomposites containing multiple fillers of arbitrary shapes is proposed. The regular or irregular filler shape is approximated by a polygon. The contact status between two fillers is identified by a sequential side-by-side procedure. An effective fitting app…
An oxygen-deficient phase has been formed by pulsed-laser ablation of strontium titanate under vacuum conditions $({10}^{\ensuremath{-}7}\phantom{\rule{0.3em}{0ex}}\mathrm{mbar})$. By the complementary use of Rutherford backscattering spectrometry and x-ray diffraction, the composition and structure of films were dete…
In this letter, the authors report the observation of metal-enhanced fluorescence emission from fluorophores deposited on copper (Cu) substrates. Different thicknesses of Cu particulate films (from 1 to 5nm) were deposited onto glass slides using thermal vapor deposition. Fluorophores positioned in close proximity to…