W. C. Banks、K. F. Skidmore、H. Schwartzbart1974-05-01Journal of Pressure Vessel Technology
An extensive investigation of the mechanical properties of cast ASTM A216 steel WCB and WCC grades, as functions of composition, heat treatment and casting thickness is reported. Castings in section thicknesses ranging from 2 1/2 in. to 10 in. were produced from twenty-two commercial size heats by five different found…
Metallurgical Processes and ThermodynamicsMetallurgy and Material FormingMetal Alloys Wear and Properties
Richard H. Schumm、E.J. Prosen、Donald D Wagman1974-05-01Journal of Research of the National Bureau of Standards Section A Physics and Chemistry
When chlorine (real gas , 980 mmHg) combines with white (a) phosphorus to form phosphorus pentachloride at 24.89 C, 3986.32.7 J of heat are liberated per gram of stoichiometrically equivalent Mg,P,07. This value was determined by a dead-ended flow system in an electrically calibrated isoperibol calorimeter. Correction…
Chemical Reaction MechanismsThermal and Kinetic AnalysisChemical Thermodynamics and Molecular Structure
В. М. Гаврилов、A. G. Shvarts1974-05-01Rubber Chemistry and Technology
Abstract Values of the polymer-solvent interaction parameter were obtained for cis -1,4-poly(butadiene) vulcanized with alkylphenol—formaldehyde oligomer, sulfur, and peroxide systems swollen with heptane, benzene, and m -xylene. The dependence of the interaction parameter on the degree of crosslinking was demonstrate…
Synthesis and properties of polymers
D. Korn、W. Mürer、G. Zibold1974-05-01Le Journal de Physique Colloques
The amorphous alloys are quench-condensed from the vapour phase on a substrate at 4 K. The electrical resistivity of amorphous Ge + 41 at. % Au, Bi + 15 at. % Ag and Sn + x at. % Cu (x = 10 to 80) is measured. An unusual linear temperature dependence is found with negative dope for Ge, Bi and Sn alloys and with a posi…
Thermodynamic and Structural Properties of Metals and AlloysAdvanced Materials and Semiconductor TechnologiesMetallurgical and Alloy Processes
E. R. Harrell、Richard P. Chartoff1974-05-01Polymer Engineering and Science
Abstract The effect of changes in crystallinity on the β‐transition in poly(vinyl chloride) was studied by dynamic mechanical measurements of loss tangent (tan δ) and storage modulus ( E ′) over the temperature range −160° to 85°C. Four frequencies were covered, 3.5, 11, 35, and 110 Hz. The data presented demonstrate…
Polymer crystallization and propertiesMaterial Properties and ProcessingPolymer Science and PVC
Ming Sung Tung、Robert F. Steiner1974-05-01European Journal of Biochemistry
The self‐association of chymotrypsinogen A at pH 8.1 and at ionic strength of 0.021 has been examined by means of sedimentation equilibrium. The data have been analyzed by several methods and results compared. Application of the older methods available in the literature indicate that the concentration dependence of mo…
Spectroscopy and Quantum Chemical StudiesCrystallization and Solubility StudiesChemical and Physical Properties in Aqueous Solutions
Chiu‐Hsiung Hwo、Julian F. Johnson1974-05-01Journal of Applied Polymer Science
This work used a conventional thermomechanical analyzer (TMA) to measure the depth of indentation at room temperature of elastomers and Finkin's equation to calculate Young's moduli of elastomers, which have been measured by Drutowski, from the radius of contact of an indentor on thin sheets of sample. Data obtained f…
Textile materials and evaluationsMaterial Properties and Applications
B. M. Gatehouse、B. K. Miskin1974-05-01Acta Crystallographica Section B
The mineral brazilianite, NaAI3(PO4)2(OH)4, is monoclinic, space group P21/n, with a = 11.233 (6), b = 10142 (5), c=7-097 (4) ,& and fl=97.37 (2) A~. With Z = 4 the calculated density, 2.998 (4), compares well with the measured density, 2.98 (1) gcm -3. The structure was solved by direct phasing and Fourier techniques…
Crystal Structures and PropertiesChemical Synthesis and CharacterizationX-ray Diffraction in Crystallography
Katsuhiro Kuroda、Hirotaka Ebisui、Tatsuro Suzuki1974-05-01Journal of Applied Physics
The characteristics of an accelerating lens system composed of three anodes in the scanning electron microscope are described. The main advantages of this accelerating lens system are that the working distance can be changed freely or the accelerating voltage can be changed over a wide range (about 0.3–100 kV) without…
Advanced Electron Microscopy Techniques and ApplicationsAdvancements in Photolithography TechniquesElectron and X-Ray Spectroscopy Techniques
B. Suryanarayanan、B. W. Peace、K. G. Mayhan1974-05-01Journal of Polymer Science Polymer Chemistry Edition
Abstract A study was conducted of the anionic polymerization of a series of methyl‐ and/or phenyl‐substituted five‐membered cyclocarbosiloxanes. The polymerization was initiated by lithium n ‐butyldiphenylsilanolate in the presence of tetrahydrofuran. The rate of conversion of monomer to polymer was measured in an NMR…
Polyoxometalates: Synthesis and ApplicationsSynthetic Organic Chemistry MethodsSilicone and Siloxane Chemistry
R. Blinc、Stjepan Lugomer、B. Žekš1974-05-01Physical Review A
The dynamic properties of the molecular model proposed by Maier-Saupe (MS) for nematic liquid crystals are investigated. It is shown that the model predicts diffusive optic soft modes, describing nematic-order-parameter fluctuations which condense at the isotropicnematic stability limit. Since the MS Hamiltonian in it…
Liquid Crystal Research AdvancementsNonlinear Dynamics and Pattern FormationMolecular spectroscopy and chirality
M. D. Dennis、R. C. Bradt1974-05-01Journal of Applied Physics
90° ferroelectric domain boundaries were observed by direct transmission electron microscopy in single crystals of pure BaTiO3 and (Ba,Pb)TiO3 solid solutions. Domain-wall thickness measurements were made from electron image plates by a densitometer-trace-curve-fitting technique. Boundary widths varied from 50 to 150…
Ferroelectric and Piezoelectric MaterialsUltrasonics and Acoustic Wave PropagationAcoustic Wave Resonator Technologies
Tetsurō Nakamura1974-05-01Chemistry Letters
Abstract BaThO3 had an orthorhombic lattice (a=6.345Å, b=6.376Å, c=8.992Å) with four pseudomonoclinic perovskite units(a′=c′=4.498Å, b′=4.496Å, β=90°17′). Ba2(BaU)O6 was a tetragonal, ordered perovskite(a=b=6.286Å, c=8.972Å). Ahrens′ radius of octahedral Ba2+ in Ba2(BaU)O6 was evaluated to be 1.16Å via a lattice param…
Perovskite Materials and ApplicationsCrystal Structures and PropertiesSolid-state spectroscopy and crystallography
M. J. Harding、B. Briat1974-05-01Molecular Physics
The absorption and magnetic circular dichroism (MCD) spectra of a single crystal of [K(H2O)6][Al(Cr)(H2O)6](SO4)2, with an aluminium : chromium ratio of approximately 10 : 1, have been measured in the range 14 500–33 000 cm-1 at various temperatures between 5 and 300 K. An analysis of the temperature dependence of the…
Magnetism in coordination complexesSolid-state spectroscopy and crystallographyMolecular spectroscopy and chirality
James E. Shelby1974-05-01Journal of Applied Physics
Helium, deuterium, and neon permeability, diffusivity, and solubility have been measured for CGW-7740 glass. The results indicate that gas migration occurs primarily through the silica-rich phase. Reaction of deuterium with the glass structure is evident at temperatures exceeding 300°C. The activation energy associate…
Luminescence Properties of Advanced MaterialsGlass properties and applicationsAdvanced Condensed Matter Physics
C. Y. Fong1974-05-01Journal of Physics F Metal Physics
An improved band structure of Pd calculated by the empirical pseudopotential method is used to compute the density of states and the reflectivity, R( omega ). The reflectivity of Pd with dipole matrix elements calculated by the actual wave functions is given for 0<or=h(cross) omega <or=10eV and is compared with measur…
Electron and X-Ray Spectroscopy TechniquesSurface Roughness and Optical MeasurementsSurface and Thin Film Phenomena
Vincenzo Brandani1974-05-01Industrial & Engineering Chemistry Fundamentals
ADVERTISEMENT RETURN TO ISSUEPREVArticleNEXTUse of Infinite-Dilution Activity Coefficients for Predicting Azeotrope Formation at Constant Temperature and Partial Miscibility in Binary Liquid MixturesVincenzo BrandaniCite this: Ind. Eng. Chem. Fundamen. 1974, 13, 2, 154–156Publication Date (Print):May 1, 1974Publicatio…
Process Optimization and IntegrationCrystallization and Solubility StudiesField-Flow Fractionation Techniques
Taisuke Seta、Noriyuki Arai、T. Udo1974-05-01IEEE Transactions on Power Apparatus and Systems
Various types of insulators have been energized with ±250 kV dc voltage and exposed to natural conditions by the seaside continuously. Salt deposit density and flashover phenomenon of these insulators have been investigated extensively for about two years. According to the results obtained so far, the influence of dc…
High voltage insulation and dielectric phenomenaLightning and Electromagnetic PhenomenaHigh-Voltage Power Transmission Systems
Victor E. Maroni、Ellen J. Hathaway、George Papatheodorou1974-05-01The Journal of Physical Chemistry
ADVERTISEMENT RETURN TO ISSUEPREVArticleNEXTExistence of associated species in lanthanum (III) chloride-potassium chloride meltsVictor E. Maroni, Ellen J. Hathaway, and G. N. PapatheodorouCite this: J. Phys. Chem. 1974, 78, 11, 1134–1135Publication Date (Print):May 1, 1974Publication History Published online1 May 2002…
Glass properties and applications
Robert F. Drake、Van H. Crawford、Nancy W. Laney 等 4 位作者1974-05-01Inorganic Chemistry
ADVERTISEMENT RETURN TO ISSUEPREVArticleNEXTMagnetic properties of di-.mu.-chlorobis[dichloro(guaninium)copper(II)] dihydrate. Second determinationRobert F. Drake, Van H. Crawford, Nancy W. Laney, and William E. HatfieldCite this: Inorg. Chem. 1974, 13, 5, 1246–1249Publication Date (Print):May 1, 1974Publication Histo…
Metal complexes synthesis and propertiesCrystal structures of chemical compoundsMagnetism in coordination complexes