Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
We have synthesized a range of photolabile conjugates of 3,5-dimethoxybenzoin with acetyl salicylic acid, ibuprofen, and ketoprofen. These conjugates can be precisely kinetically controlled to liberate free drug following exposure to 365 nm light for defined periods. Incorporation of the conjugates into limited-porosi…
High Resolution Image Download MS PowerPoint Slide We report vapor-phase synthesis of single-crystalline free-standing Ag nanowires and polarized surface-enhanced Raman scattering (SERS) of a single nanowire, as a first step toward fabrication of well-controlled nanobiosensors employing the SERS technique.
We study the influence of deformations on magnetic ordering in quantum dots doped with magnetic impurities. The reduction of symmetry and the associated deformation from circular to elliptical quantum confinement lead to the formation of piezomagnetic quantum dots. The strength of elliptical deformation can be control…
Using the first-principles spin density functional approach, we have studied magnetism of a new type of all-carbon nanomaterials, i.e., the carbon nanowires inserted into the single-walled carbon nanotubes. It is found that if the 1D carbon nanowire density is not too higher, the ferromagnetic ground state will be mor…
Significant nanoscale disorder of Cu and Ca atomic substitution is observed in CaCu(3)Ti(4)O(12), based on our integrated study using quantitative electron diffraction and extended x-ray absorption fine structure. Unambiguous identification of this previously omitted disorder is made possible by the unique sensitivity…
We report the successful passivation of the Mn acceptors in GaMnP upon exposure to a remote dc hydrogen plasma. The as-grown films are non-metallic and ferromagnetic with a Curie temperature of T_C=55K. After hydrogenation the sample resistivity increases by approximately three orders of magnitude at room temperature…
We present a segregated strain model that can describe the thickness-dependent dielectric properties of epitaxial ferroelectric films. Using a phenomenological Landau approach, we present results for two specific materials, making comparison with experiment and with first-principles calculations whenever possible. We…
By sequential feeding of catalyst materials, it is revealed that the active growth sites are at the bottom of the carbon nanotubes (CNTs), and that catalyst particles are constantly encapsulated into nanotubes from the bottom. This gives a better insight into the mechanism of CNT formation and on ways to control the g…
A novel strategy for the large scale and continuous production of aligned carbon nanotube arrays using millimeter-diameter spheres as growth substrates is reported. The present technique is more productive than the conventional process on flat wafers because of the higher available growth surface and the good fluidity…
Abstract Poly(lactic acid) (PLA) blended with poly(butylene succinate) (PBS) was prepared in the presence of lysine triisocyanate (LTI) by using a twin‐screw extruder and injection molding machine. The physical properties, rheological behavior, compatibility, and morphology were investigated by using a tensile test, a…
Manganese oxides and iron-manganese oxides supported on TiO2 were prepared by the sol-gel method and used for low-temperature selective catalytic reduction (SCR) of NO with NH3. Base on the previous study, Mn(0.4)/ TiO2 and Fe(0.1)-Mn(0.4)/TiO2 were then selected to carry out the in situ diffuse reflectance infrared t…
Abstract Poly(vinyl alcohol) (PVA) fibrous mats dealt with polyoxometalate containing vanadium were prepared by electrospinning method. The fibrous mats were characterized by infrared spectra, X‐ray powder diffraction patterns, and scanning electron microscopy photographs. The results showed that PVA could combine wit…
We use the Gutzwiller variational many-body theory to investigate the stability of orbitally ordered states in a two-band Hubbard model without spin degrees of freedom. Our results differ significantly from earlier Hartree–Fock calculations for this model. The Hartree–Fock phase diagram displays a large variety of orb…
Abstract In this study, optimum condition for the reaction of glycidyl methacrylate (GMA), epichlorohydrin (ECH), and propylene oxide (PO) with oil palm empty fruit bunch (EFB) were determined. The treated EFB was characterized using Fourier transform infrared (FTIR), wide‐angle X‐ray diffraction (WAXD), and different…
Succinyl-CoA synthetase has a highly conserved cysteine residue, Cys123alpha in the Escherichia coli enzyme, that is located near the CoA-binding site and the active-site histidine residue. To test whether the succinyl moiety of succinyl-CoA is transferred to the thiol of Cys123alpha as part of the catalytic mechanism…
Abstract The effects of ultrasonic oscillations on the die pressure, productivity of extrusion, melt apparent viscosity, melt surface appearance, and die swell of novel propylene‐based plastomers were studied in a specially designed ultrasonic oscillations extrusion system developed in our laboratory. The effects of u…
The structure of Ba(3)BaSb(2)O(9) is reported for the first time as a high-temperature phase with an ideal hexagonal BaTiO(3)-type structure (space group P6(3)/mmc) and Rietveld-refined against high-temperature synchrotron X-ray powder diffraction data. The structure is remarkable for the extreme size difference betwe…
Abstract In this paper, short carbon‐fiber‐reinforced nylon 6/clay nanocomposites are prepared via melt compounding, and fiber breakage and dispersion during processing are studied. The influences of clay and processing conditions on fiber breakage and dispersion are taken into consideration. It is found that the pres…
We present a hybrid method to investigate the isotropic-nematic (I-N) transition in athermal solutions of rod-coil copolymers. This method incorporates the scaled-particle theory for semiflexible chains with two-chain Monte Carlo simulation for the osmotic second virial coefficient and for the angle-dependent excluded…
Hollow needles can be produced by immersing certain hydrate crystals in alcohol solution (methanol or ethanol). The fact that these anhydrate needles are hollow was proven by confocal fluorescence microscopy. For one material (sodium 2-keto- l -gulonate anhydrate) it is shown here that the internal diameter can be con…