Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
Amorphous wires are prepared by the in-water quenching technique. This procedure gives rise to local magnetoelastic anisotropies arising from the coupling between frozen-in internal stresses and magnetostriction. Azimuthal and axial components of internal stresses have been experimentally confirmed by the asymmetry of…
Formation and desorption of aluminum hydride from hydrogen covered Al(110), Al(100), and Al(111) has been investigated, using thermal desorption spectroscopy. Both desorption of aluminum hydride and molecular hydrogen has been detected with branching ratios depending on surface structure. Production of aluminum hydrid…
The surface core-level shifts of the Al(100) and Al(111) surfaces have been measured by high-resolution photoelectron spectroscopy. For the Al(100) surface we obtain a value of (-96\ifmmode\pm\else\textpm\fi{}5) meV. This value is in excellent agreement with a recent ab initio calculation by Feibelman. The surface cor…
Polarized reflectance spectra of a single crystal of κ-(BEDT-TTF) 2 I 3 were measured at 295 K and 15 K over the spectral range from 500 cm -1 to 25000 cm -1 . The infrared property was two-dimensional. Non-Drude mid-infrared features were observed in spite of the metallic dc conductivity. A comparison with β- and θ-(…
Mechanical alloying is applied to prepare Nd-Fe-B, Sm-Fe-TM type (TM: V, Ti, Zr), and interstitial nitride and carbide permanent magnets. Starting from elemental powders, the hard magnetic phases are formed by milling in a planetary ball mill and a following solid-state reaction at relatively low temperatures. For Nd-…
The x-ray structure of a short-chain dehydrogenase, the bacterial holo 3 alpha,20 beta-hydroxysteroid dehydrogenase (EC 1.1.1.53), is described at 2.6 A resolution. This enzyme is active as a tetramer and crystallizes with four identical subunits in the asymmetric unit. It has the alpha/beta fold characteristic of the…
The high (BH)max potential of Nd-Fe-B materials make them excellent candidates for bonded magnets. We have previously shown that anisotropic bonded magnets can be made from hot deformed rapidly solidified materials. The purpose of this paper is to show how hot deformed materials can be pulverized into desired particle…
The lattice parameters and the saturation magnetization are measured for the series of intermetallic compounds A(Fe,B)2, A=Zr, Hf and B=Si and Al, with concentrations less than 15%. The magnetization measurements and the lattice parameter behavior are qualitatively discussed.
[C2sH 32 Fe2 N6 ° 5]( C10 4)2.0.9( C3H60 ) CROMER, D. T. (1974). International Tables for X-ray Crystal- lography, Vol. IV, Table 2.3.1 Birmingham: Kynoch Press. CROMER, D. T. & WABER, J. T. (1974). International Tables for X-ray Crystallography, Vol. IV, Table 2.2B. Birmingham; Kynoch Press. (Present distributor Kluw…
Melt-spun Nd-Fe-B ribbons are limited to remanences of about 8 kG by the random orientation of the Nd2Fe14B grains. Hot deformation (die upsetting) causes these grains to reorient with the c axis aligned along the press direction, resulting in a 50% increase in the remanence (12 kG). Previously others have produced ma…
Magnetic properties of RTiCo11 (R=Y, La, Ce, Pr, Nd, Sm, Gd, Tb, Dy, Ho, and Er) compounds with the ThMn12 structure were investigated in the temperature range from 4.2 to 1400 K. The Curie temperatures of this series exceed 1000 K and the Co atomic moments were found to take the values ranging from 0.99 to 1.80 μB, w…
The magnetic and structural properties of Co100−xMnx alloys have been studied in the range 0≤x≤50 at. %. The structural phase diagram, which was revised with the aid of resistivity and thermal-expansion measurements for 4<T<1200 K, shows that the fcc↔hcp (γ↔ε) martensitic transformation temperature in Co…
The magnetic properties of Nd17Fe76.5B5Cu1.5-type sintered magnets, produced using a combination of hydrogen decrepitation and milling, have been investigated. An isothermal anneal or a step anneal, both performed after homogenization, resulted in a marked improvement of magnetic properties of the sintered magnets. Th…
We have carried out neutron diffraction measurements on powder samples of Nd2Fe17Nx and Y2Fe17Nx at room temperature. The refinements of the neutron data indicate that the nitrogen atoms occupy the 9e interstices in the nitride Nd2Fe17Nx (Th2Zn17 type, R3̄m) or the 6h interstices in the nitride Y2Fe17Nx (Th2Ni17 type,…
Quasistatic and dynamic measurements of the magnetic field induced magnetoelectric polarization (MEH effect) have been performed in the weakly ferromagnetic/ferroelectric/ferroelastic phase of point group m′m2′ of Ni-Cl boracite between 1.8 and 9 K (=TC) and above. For the first time the quadratic MEH effect of Ni-Cl…
Thermal quenching mechanism of Yb intra-4f-shell luminescence were clarified by studying the temperature dependences of electrical and optical properties of Yb-doped InP samples. The quenching mechanism which depends on shallow donor concentration was found by comparing temperature dependences of Yb 4f-shell luminesce…
We present a set of angle-integrated inverse-photoemission data on ${\mathrm{Fe}}_{2}$${\mathrm{O}}_{3}$ taken in the ultraviolet region (12.1--24.2 eV) in the isochromat mode. The photon-energy dependence of the spectra gives direct insight into the orbital origin of the empty electron states in the oxide. The result…
ADVERTISEMENT RETURN TO ISSUEPREVArticleNEXTChemical modulation of the electron work functionJiri. JanataCite this: Anal. Chem. 1991, 63, 22, 2546–2550Publication Date (Print):November 15, 1991Publication History Published online1 May 2002Published inissue 15 November 1991https://pubs.acs.org/doi/10.1021/ac00022a003ht…
A new stable compound in the Nd–Fe system has been identified as Nd5Fe17. The crystal structure belongs to the hexagonal space group P63/mcm, with a=2.0214(8) nm and c=1.2329(8) nm, and with 12 formula units per unit cell. This compound is a ferromagnet with Tc = 503 K and magnetization 162 emu/g at 4.2 K. Mössbauer s…
The effect of additives has been studied for the Sm2Fe17Nx compounds. Only Co addition increases the Curie temperature. The Ti, V, or Co additions increase the anisotropy field. The additions of these elements are favorable for the magnet fabrication. The magnet fabrication has been carried out by the Zn metal bonding…