Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
The purpose of this article is to present the design and capabilities of two in situ scanning electron microscope (SEM) indentation instruments covering a large load range from microN to N. The capabilities and advantages of in situ SEM indentation are illustrated by two applications: indentation of a thin film and a…
The dielectric properties of single-phase BiFeO3 (BFO) thin films were investigated based on parallel-plate electrode (PPE) and coplanar interdigital electrode (CIE) configurations across a wide frequency range of 100 Hz–10 GHz. The dielectric dispersion in the PPE configuration, caused by the interfacial polarization…
The valence and conduction band structures of In2O3 have been measured using a combination of valence band x-ray photoemission spectroscopy, O K-edge resonant x-ray emission spectroscopy, and O K-edge x-ray absorption spectroscopy. Excellent agreement is noted between the experimental spectra and O 2p partial density…
Co and Al co-doped ZnO diluted magnetic semiconductors are fabricated by a pulsed laser deposition and their electronic structure is investigated using x-ray absorption and emission spectroscopy. The Zn(0.895)Co(0.100)Al(0.005)O thin films grown under oxygen-rich conditions exhibit ferromagnetic behavior without any i…
Quartz-binding peptides (QBPs) are used as both ink and linker for microcontact printing and self-assembly, for the co-immobilization of streptavidin-coated quantum dots and fluorescein. Directed assembly of the quantum dots is carried out following microcontact printing of biotinylated QBP1 on a quartz surface. The r…
Treating freshly prepared cerous hydroxide with hydrogen peroxide (H 2 O 2 ) under ambient conditions provides a facile and efficient way for converting CeO 2 nanoparticles (∼22 nm, 37 m 2 /g) into nanowires of fine diameters (down to ∼5 nm) and outstanding specific surface areas (∼184 m 2 /g). The CeO 2 nanomaterials…
In this study, we report for the first time the fabrication of polymer nanospheres, nanocapsules, and hemispherically capped nanorods simply through the wetting of anodic aluminum oxide (AAO) membranes with polymer solutions. For the wetting with polystyrene solutions, we have demonstrated that the formation of nanoro…
A new method of protein detection was explored on the resonant Raman scattering signal of ZnO nanoparticles. A probe for the target protein was constructed by binding the ZnO/Au nanoparticles to secondary protein by eletrostatic interaction. The detection of proteins was achieved by an antibody-based sandwich assay. A…
The role of nanotwin lamellae in enhancing thermal stability of nanostructured materials is examined. Nanostructured copper with varying densities of twins was generated by controlling the deformation strain rate during severe plastic deformation at cryogenic temperatures. While the nanostructured materials produced u…
Gold nanoparticles are used as a luminescent contrast agent to study size-dependent dynamics in polymer matrix. The experiments measured the diffusion coefficient of particles in poly(butyl methacrylate) melt by tracking their motion within a diffraction-limited focus of a laser with 150 fs pulses at 800 nm. Our resul…
Abstract The kinetics of point‐defect association/dissociation reactions in Ce 0.8 Gd 0.2 O 1.9 and their influence on the crystal lattice parameter are investigated by monitoring thermally induced stress and strain in substrate‐ and self‐supported thin films. It is found that, in the temperature range of 100–180 °C,…
High aspect ratio BaTiO(3) nanotube arrays with single crystal structure were fabricated by the hydrothermal method at low temperature (150 degrees C). Numerous structure study methods, including x-ray diffraction (XRD), Raman spectroscopy, transmission electron microscopy (TEM), electron paramagnetic resonance (EPR),…
Water-soluble silsesquioxane nanoparticles (NPs) incorporating viologen groups (PXV; 1,1'-bis[3-(trimethoxysilyl)propyl]-4,4'-bipyridinium iodide) have been synthesized by sol-gel polymerization. The electrochromic properties of the bulk film fabricated by layer-by-layer (LbL) assembly have been examined, along with t…
Single crystals of diamond up to 18 mm in thickness have been grown by microwave plasma assisted chemical vapor deposition at gas pressures of up to 350 torr. Growth rates of up to 165 μm/h at 300 torr at high power density have been achieved. The processes were evaluated by optical emission spectroscopy. The high-qua…
In order to obtain information on the nature of the “hot” sites in surface-enhanced Raman scattering, we have fabricated a model nanostructure composed of 4-aminobenzenethiol (4-ABT) that has further been sandwiched between Au nanoparticles and a macroscopically smooth Au substrate. In the absence of Au nanoparticles,…
Beta-MnO(2) nanorods were synthesized via a redox reaction of (NH(4))(2)S(2)O(8) and MnSO(4) under hydrothermal conditions. In situ and ex situ x-ray diffraction and scanning electron microscopy were employed to follow the structural and morphological evolution during growth. It was found that the crystallization of b…
Fabrication of efficient semiconductor-sensitized bulk heterojunction solar cells requires the complete filling of the pore system of one semiconductor (host) material with nanoscale dimensions (<100 nm) with a different semiconductor (guest) material. Because of the small pore size and electrical conductivity of the…
By using terahertz time-domain spectroscopy and rigorous simulations, we investigate the impact of gap orientation of neighboring split rings on the three lowest order eigenmodes for a metamaterial based on split ring resonators. We distinct scenarios where neighboring split rings have their gap either on the same or…
The major problem in drug delivery to the brain is the presence of the blood-brain barrier (BBB) which limits drug penetration even if in certain pathological situations the BBB is partly disrupted. Among noninvasive techniques to overcome this barrier, the use of nanoparticles has been proposed. This review focuses o…
In situ transmission electron microscopy tensile experiments were carried out to investigate lattice dislocation and twin boundary (TB) interaction in Cu with nanoscale growth twins. Results show that extended dislocations form inside thick twin lamellas and slip toward TBs. The extended dislocations shrink, combine,…