Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
Ultrawideband dielectric spectroscopy analysis of barium zirconate titanate (BaZrxTi1−xO3, BZT) ceramics at different temperatures disclosed the contribution of both the dipole and the ionic polarizations to permittivity at around dielectric maximum temperature (Tm). In BaZr0.25Ti0.75O3 ceramics, the permittivity arou…
The control of charge-ordering-insulating (COI) phase in epitaxial La1−xCaxMnO3/NdGaO3(001) (x=0.30–0.45) thin films with essentially the ferromagnetic metal ground state as observed for the bulk counterparts has been realized via the anisotropic strain relaxation. This epitaxial system is special in that there is a n…
A light weight composite material has been prepared using banana empty fruit bunch fibre (banana-EFB) as reinforcement in polyester resin matrix, and its mechanical properties studied. The composites are formulated up to a maximum fibre volume fraction of about 0.37, resulting in a mean tensile strength of 43 MPa and…
This paper proposes an equivalent circuit which characterizes the dynamic supercapacitor behavior over a wide charge and discharge frequency range (0-1 kHz). The model takes into account the actual frequency response of the device. In addition, a new simple procedure, based on a constant current charge, to identify th…
We investigate structural color filters theoretically and experimentally using polymer-based guided-mode resonant gratings fabricated by nanoimprint lithography. Each grating area is 200 × 200 µm 2 , which is a suitable pixel size for displays and multichannel detectors. In the mold fabrication, electron beam lithogra…
We demonstrated a marked improvement of sensitivity (signal-to-noise ratio) in carbon nanotube field-effect transistor (CNTFET) sensors. The alternating current (AC) measurement with a lock-in amplifier, which suppresses the fluctuations in drain current in CNTFETs without decreasing the signal level, was adopted. The…
We studied the absorptive and refractive nonlinearities at 532 nm and 26 ps pulses for silicon-nitride films containing silicon nanoclusters (nc-Si) prepared by remote plasma-enhanced chemical vapor deposition (RPECVD). Using a self-diffraction technique, we measured for the as-grown sample beta=7.7x10(-9)m/W, n(2)=1.…
Different silicon nanocrystal (Si NC) systems in which Si NCs were either entirely isolated or loosely interconnected were studied by photoluminescence (PL) and time-resolved PL decay measurements in the range between 70 and 290 K, in order to investigate the role of exciton migration in the PL properties. We examined…
This paper evaluates and compares the electromagnetic (EM) shielding characteristics of a diverse range of conductive fabrics in order to analyse their suitability for use in wearable medical applications. The Shielding Effectiveness (SE) was characterised in terms of fabric structures, conductive materials, mass, thi…
It is generally known that the solid char obtained from pyrolysis of scrap rubber tires can be used as an adsorbent for several applications such as wastewater treatment. In this study, scrap tires were first pyrolyzed under nitrogen (N2) or carbon dioxide (CO2) gas under various temperatures to produce char. The char…
Charge generation in cross-linked polyethylene (XLPE) and ethylene propylene rubber (EPR) under dc stress are influenced strongly by inclusions. The inclusions influencing charge generation are cross-linking byproducts, antioxidants, and moisture. These inclusions particularly influence the generation of negative hete…
Most dilute magnetic semiconductors exist either in ferromagnetic (e.g., GaAs:Mn) or antiferromagnetic (ZnSe:Mn) phases at low temperature. This alignment persists even after carriers are introduced, although the preference may change as a function of doping. Using first-principles calculations, we found that the stab…
Ti(5 nm)/CoCrPt(5–20 nm) bilayers with perpendicular magnetic anisotropy were deposited by rf sputtering onto porous alumina films to form antidot arrays with period 105 nm and pore diameters ranging from 18 to 56 nm. The coercivities of the antidot arrays are greater than those of unpatterned films and show only a we…
We report the results of temperature-dependent neutron powder diffraction experiments on (1−x)BiScO3–xPbTiO3 (x=0.62, 0.64, and 0.66) within the morphotropic phase boundary. In all samples the monoclinic phase is found to coexist with the tetragonal phase below the ferroelectric transition temperature. The details of…
Soft magnetic composites consisting of an organic binder and FeCoV particles have been produced and examined afterward regarding the dependence of magnetic field H at polarization J on filler content C. In general, the applied magnetic field to achieve a certain value of polarization is proportional to the inverse fil…
A modified sol-gel method is used for synthesizing Nd ion doped lead zirconate titanate nanopowders Pb 1–3 x /2 Nd x Zr 0.52 Ti 0.48 O 3 (PNZT) in an ethylene glycol system with zirconium nitrate as zirconium source. The results show that it is critical to add lead acetate after the reaction of zirconium nitrate with…
Ultrafine TiB 2 , ZrB 2 , and ReB 2 powders were prepared by the metallothermic reduction method using Mg. Obtained TiB 2 , ZrB 2 , and ReB 2 powders were characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, dynamic light scattering, and scratch test. The morphology of th…
The magnetic properties and magnetocaloric effects of Ni(50-x)Mn(38+x)Sb(12) ferromagnetic shape-memory alloys with x = -1, 0, 1 and 2 that undergo a martensitic transformation were investigated. The magnetic-entropy changes Delta S of nominal Ni(49)Mn(39)Sb(12), or Ni(49.5)Mn(38.6)Sb(11.9), at 279K is 6.15 J kg(-1) K…
We have found that magnetostrictive FeBSiC alloy ribbons laminated with piezoelectric Pb(Zr,Ti)O(3) fiber can act as a tunable transformer when driven under resonant conditions. These composites were also found to exhibit the strongest resonant magnetoelectric voltage coefficient of 750 V/cm-Oe. The tunable features w…
Interconnect process features are described for a 32 nm high performance logic technology. Lower-k, yet highly manufacturable, carbon-doped oxide (CDO) dielectric layers are introduced on this technology at three layers to address the demand for ever lower metal line capacitance. The pitches have been aggressively sca…