Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
The effect of aluminum doped zinc oxide film used between a fluorine doped tin oxide layer and a hydrogenated amorphous silicon carbide layer to improve the open circuit voltage (Voc) and fill factor (FF) for high efficiency thin film solar cells. The efficiency enhancement was accomplished by the insertion of high wo…
Abstract The use of reactive gases for syntheses on small laboratory scale is often avoided due to safety concerns so that expensive alternatives are required. The recent development of gas‐permeable membrane‐based reactors offers new options for safe handling of these gases in a continuous‐flow system. A prototype of…
By means of combining a very cost-effective lift-off process and a nanosphere lithography technique, we have fabricated two dimensional (2D) photonic crystal (PhC) structures on an InGaN/GaN multiple quantum well structure. Significant enhancement in photoluminescence (PL) intensity has been observed when the emission…
An efficient charge transfer between co-sublimed cesium carbonate (Cs2CO3) and fullerene C60 provides an n-type material exhibiting an electrical conductivity above 1 S/cm. This type of doped layers can be used in organic optoelectronic devices to reduce ohmic losses at organic-electrode interfaces. We report here an…
We demonstrate an approach to enhancing the photoresponsivity of a polymer photodetector (PPD). Both conventional bulk heterojunction (BHJ) and planar heterojunction (PHJ) PPDs were fabricated considering that the interface between a CdSe nanocrystal and a polymer can create photoconductive gain. A systematic study of…
Dinitrosyliron complexes (DNICs) are organometallic-like compounds of biological significance in that they appear in vivo as products of NO degradation of iron-sulfur clusters; synthetic analogues have potential as NO storage and releasing agents. Their reactivity is expected to depend on ancillary ligands and the red…
The spatial resolution in traditional optical microscopy is limited by diffraction. This prevents imaging of features with dimensions smaller than half of the wavelength (λ) of the illumination source. Superlenses have been recently proposed and demonstrated to overcome this issue. However, its implementation often in…
The two-load method is commonly used to determine the transmission loss of a muffler or silencer. Several practical measurement considerations are examined in this paper. First of all, conical adapters are sometimes used to transition between impedance tubes and the muffler. It is demonstrated that the effect of addin…
This paper presents the findings of investigating core-shell multiple quantum well nanowire light-emitting diodes (LEDs). A fully self-consistent three dimensional model that solves Poisson and drift-diffusion equations was employed to investigate the current flow and quantum-confined stark effect. The core-shell nano…
We demonstrate the vertical self-catalyzed molecular beam epitaxy (MBE) growth of GaAs nanowires on an amorphous SiO2 substrate by using a smooth [111] fiber-textured silicon thin film with very large grains, fabricated by aluminum-induced crystallization. This generic platform paves the way to the use of inexpensive…
In this letter we report single-hole tunneling through a quantum dot in a two-dimensional hole gas, situated in a narrow-channel field-effect transistor in intrinsic silicon. Two layers of aluminum gate electrodes are defined on Si/SiO2 using electron-beam lithography. Fabrication and subsequent electrical characteriz…
In this study, we reported a 36% improvement in the performance of inverted solar cells as a result of increased short-circuit current (JSC) obtained using a composition of zinc oxide (ZnO) and reduced graphene oxide (RGO) as an n-type buffer layer. RGO-ZnO nanocomposites show higher electron conductivity than intrins…
Maximizing the optical absorption of one-dimensional Si nanostructure arrays (1DSiNSAs) is desirable for excellent performance of 1DSiNSA-based optoelectronic devices. However, a quite large surface-to-volume ratio and enhanced surface roughness are usually produced by modulation of the morphology of the 1DSiNSAs prep…
Controlling axial and radial dopant profiles in nanowires is of utmost importance for NW-based devices, as the formation of tightly controlled electrical junctions is crucial for optimization of device performance. Recently, inhomogeneous dopant profiles have been observed in vapor–liquid–solid grown nanowires, but th…
The solvothermal reaction between the rigid spacer 3,3′,5,5′-tetramethyl-4,4′-bipyrazole (H 2 Me 4 BPZ) and a number of transition metal salts promoted the formation of the coordination polymers [M(Me 4 BPZ)] (M = Zn, 1; Co, 2; Cd, 3; Cu, 4 ). Ab initio X-ray powder diffraction analyses revealed the main structural as…
Trp replacements for conserved Gly-Gly pairs between the N- and C-terminal six-helix bundles on the periplasmic side of lactose permease (LacY) cause complete loss of transport activity with little or no effect on sugar binding. Moreover, the detergent-solubilized mutants exhibit much greater thermal stability than WT…
Hollow aluminosilicate zeolite beta was successfully synthesized by adding CIT-6, that is, zincosilicate zeolite, which has the same topology as beta, as seeds to the Na-aluminosilicate gel without the need for organic structure-directing agents. One important factor in the successful organic structure-directing agent…
This letter reported that a dielectric elastomer actuator (3M VHB), which is immersed in a liquid dielectric bath, is enhanced tremendously in dielectric strength up to 800 MV/m, as compared to 450 MV/m for the actuator operated in air. The bath consists of silicone oil (Dow Corning Fluid 200 50cSt), which is 6.5 time…
The high intensity of light emitted in InxGa1−xN/GaN heterostructures has been generally attributed to the formation of indium-rich clusters in InxGa1−xN quantum wells (QWs). However, there is significant disagreement about the existence of such clusters in as-grown InxGa1−xN QWs. We employ atomically resolved CS-corr…
The effects of charge accumulation on fill factor (FF) are studied by using light intensity-dependent current-voltage and capacitance-voltage measurements based on poly-{bi(dodecyl)thiophene-thieno[3,4-c]pyrrole-4,6-dione}:1(3-methyloxycarbony1)propyl-1-phenyl [6,6] (PBTTPD:PCBM) solar cells. We find that the FF of un…