Materials Literature

文献浏览

按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。

清除
第 233930 / 238282 页 · 当前展示 4,678,581–4,678,600 / 4,765,639 条匹配结果 · 摘要仅作预览

Substantial pressure effects on the electrical resistivity and ferromagnetic transition temperature ofLa1−xCaxMnO3

J. J. Neumeier、M. F. Hundley、J. D. Thompson 等 4 位作者1995-09-01Physical review. B, Condensed matter

The influence of hydrostatic pressure on the electrical resistivity \ensuremath{\rho} and ferromagnetic transition temperature ${\mathit{T}}_{\mathit{c}}$ of ${\mathrm{La}}_{1\mathrm{\ensuremath{-}}\mathit{x}}$${\mathrm{Ca}}_{\mathit{x}}$${\mathrm{MnO}}_{3}$ is presented for x=0.21, 0.33, and 0.40. Pressure strongly d…

Rare-earth and actinide compoundsMagnetic and transport properties of perovskites and related materialsAdvanced Condensed Matter Physics

Preparation of Bi-Based Ferroelectric Thin Films by Sol-Gel Method

Tsutomu Atsuki、Nobuyuki Soyama、Tadashi Yonezawa 等 4 位作者1995-09-01Japanese Journal of Applied Physics

The effects of Bi/Ta and Sr/Ta mole ratios on ferroelectric properties of Sr x Bi y Ta 2 O z [ SBIT( x / y /2.0); 0.7≤ x ≤1.0, 2.0≤ y ≤2.6] thin-film capacitors were investigated. The SBIT films were grown by the sol-gel method using a spin-on coating on Pt/Ta/SiO 2 /Si and Pt/Ti/SiO 2 /Si substrates. The films were a…

Liquid Crystal Research AdvancementsFerroelectric and Piezoelectric MaterialsAcoustic Wave Resonator Technologies

Influence of the joint incorporation of CaF2 and CaSO4 in the clinkerization process. Obtainment of new cements

María Teresa Blanco-Varela、A. Palomo、F. Puertas 等 4 位作者1995-09-01Materiales de Construccion

This article review the state of the art on the effect of the joint incorporation of fluorides and sulfates to the cement crudes. This incorporation may be carried out partially replacing the traditional crudes, thus obtaining a new cement produced with a considerable energy saving and with advantageous characteristic…

Evaluation of the water related characteristics of diverse Spanish stones after the application of different protective treatments

L. Rubio、A. Bello1995-09-01Materiales de Construccion

The characteristics related to water absorption of some important stones very used in the southern of Spain were tested before and after the application of diverse commercial protective treatments, including the application of diverse dilutions and the correlative application of two complementary products. Some consid…

Effects of Moisture on Mechanical Properties of Glass-Filled Nylon-6,6

J-C Huang、T-H. Wu、C-L Wu1995-09-01Science and Engineering of Composite Materials

The weight increases of nylon-6,6 and glass-filled nylon-6,6 after 120 days exposure at 100% and 43% relative humidities were measured. The resultant mechanical properties of nylons were evaluated. Moisture absorption was seen to affect several mechanical properties. Specifically, an increase in moisture absorption re…

Polymer crystallization and propertiesPolymer Nanocomposites and PropertiesFiber-reinforced polymer composites

TABLE OF CONTENTS

作者信息未提供1995-09-01Science and Engineering of Composite Materials

A Conductive and Humidity‐Sensitive Composite Film Derived from Poly(o‐phenylenediamine) and Polyvinyl Alcohol

Kotaro Ogura、M. Kokura、Masaharu Nakayama1995-09-01Journal of The Electrochemical Society

Electrically conducting composite films have been prepared from the polymer solution of conducting poly o‐phenylenediamine (PoPD) and nonconducting polyvinyl alcohol (PVA). This composite film showed a very low value of the percolation threshold (0.1 volume percent of the PoPD content) where the conductivity rose shar…

Conducting polymers and applicationsOrganic Electronics and PhotovoltaicsAdvanced Sensor and Energy Harvesting Materials

Effect of Morphology of Polyaniline on Its Discharge Characteristics in Nonaqueous Electrolyte

Kiyoshi Kanamura、Yasunori Kawai、Susumu Yonezawa 等 4 位作者1995-09-01Journal of The Electrochemical Society

The discharge and charge performance of polyaniline which has a fibrous morphology was investigated from microscopic current density and anion diffusion time constant measurements. The microscopic discharge current density is calculated from the radius of the polyaniline fibril, assuming the true electrode surface are…

Analytical Chemistry and SensorsFuel Cells and Related MaterialsConducting polymers and applications

Definition of clay and clay mineral: joint report of the AIPEA and CMS Nomenclature Committees

Stephen Guggenheim、R. T. Martin1995-09-01Clay Minerals

Abstract The definition of ‘clay’ was first formalized in 1546 by Agricola. It has been revised many times since, although the fundamentals involving plasticity, particle size, and hardening on firing were retained by most. For an exhaustive account of the history of the definition to 1963, the reader is referred to M…

Powder Metallurgy Techniques and MaterialsRecycling and utilization of industrial and municipal waste in materials productionClay minerals and soil interactions