Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
The interest in ulvan within a biomedical framework increases as the knowledge of this polysaccharide evolves. Ulvan has been recently proposed as a potential biomaterial, and structures based on this polysaccharide are now being studied for different biomedical applications. In this work, a novel porous structure bas…
AIM: The objective of this work was to study the photoacoustic effect of a special nanoparticle for selective cancer cell killing both in vitro and in vivo. MATERIALS & METHODS: The nanoparticles (NPs) consisting of indocyanine green (ICG), phospholipid-polyethylene glycol (PL-PEG) and folic acid (FA) were used as can…
An aluminum bow-tie nano-antenna is combined with the resonance Raman effect in the deep ultraviolet to dramatically increase the sensitivity of Raman spectra to a small volume of material, such as benzene used here. We further demonstrate gradient-field Raman peaks for several strong infrared modes. We achieve a gain…
Structural plasticity is often required for distinct microscopic steps during enzymatic reaction cycles. Adenylate kinase from Escherichia coli (AK(eco)) populates two major conformations in solution; the open (inactive) and closed (active) state, and the overall turnover rate is inversely proportional to the lifetime…
Dense and uniform polymer brush coatings were developed to combat marine biofouling. Nonionic hydrophilic, nonionic hydrophobic, cationic, anionic and zwitterionic polymer brush coatings were synthesized via surface-initiated atom transfer radical polymerization (SI-ATRP) of 2-hydroxyethyl methacrylate, 2,3,4,5,6-pent…
Telechelic, RAFT (reversible addition-fragmentation chain transfer)-derived macromonomers with a pyridyl disulfide end-group were converted into high molecular weight, disulfide-linked polymers using a polycondensation, step-growth procedure. The applicability of the method to polycondense a library of macromonomers w…
We present a direct magnetic imaging study on the thermal macrospin ordering of artificial kagome spin ice building blocks. Using photoemission electron microscopy, employing x-ray magnetic circular dichroism, we are able to resolve the single domain magnetic nature of the macrospins and determine the states of the co…
The degradation of CuInSe2 absorbers in ambient air is observed by the decay of the quasi-Fermi level splitting under well defined illumination with time. The decay is faster and stronger in absorbers with [Cu]/[In]<1 than in ones with a higher ratio. It can be attributed to the oxidation of the sample. Epitaxial film…
In this paper, we extract density of localized tail states from measurements of low temperature conductance in amorphous oxide transistors. At low temperatures, trap-limited conduction prevails, allowing extraction of the trapped carrier distribution with energy. Using a test device with a-InGaZnO channel layer, the e…
High-performance Schottky diodes based on palladium blocking contacts were fabricated upon depositing indium-gallium-zinc oxide (IGZO) with high oxygen content. We find that an oxygen treatment of the palladium contact is needed to achieve low off currents in the Schottky diode, and rationalize this by relating an inc…
Abstract Silicon is now firmly established as a high performance photonic material. Its only weakness is the lack of a native electrically driven light emitter that operates CW at room temperature, exhibits a narrow linewidth in the technologically important 1300–1600 nm wavelength window, is small and operates with l…
The evolution with time of interface trap density and bulk density of states in amorphous-indium-gallium-zinc-oxide thin-film transistors (TFTs), for negative-bias-under-illumination-stress (NBIS), is traced. Based on the combined analysis of TFT current-voltage and capacitance-voltage characteristics, position of Fer…
Bottom-gate thin film transistors with amorphous zinc tin oxide channels were grown by atomic layer deposition (ALD). The films maintained their amorphous character up to temperatures over 500 \\(^{\\circ}\\)C. The highest field effect mobility was ~13 \\(cm^2/V^.s\\) with on-to-off ratios of drain current ~10\\(^9\\)…
High-mobility organic thin film transistors based on a benzobisthiadiazole-containing polymer are presented together with their morphological and optical properties. A very tight packing pattern of "edge-on" orientated polymer chains is observed in their thin films after annealing, and the hole mobility of this polyme…
Gaseous compounds, particle number and size distribution measurements on a gasoline direct injection (GDI) vehicle and a port fuel injection (PFI) vehicle were conducted over the U.S. Federal Test Procedure 75 (FTP-75) and US06 Supplemental Federal Test Procedure (US06) on Tier 2 certification gasoline (E0) and a 10%…
We examine the effect of vacancies on the phase behavior and structure of systems consisting of hard cubes using event-driven molecular dynamics and Monte Carlo simulations. We find a first-order phase transition between a fluid and a simple cubic crystal phase that is stabilized by a surprisingly large number of vaca…
Topological insulators are a novel quantum state of matter that reveals their properties and shows exotic phenomena when combined with other phases. Hence, priority has been given to making a good quality topological insulator interface with other compounds. From the applications point of view, the topological insulat…
Abstract A group of dendrimers with oligo‐carbazole dendrons appended at 4,4′‐ positions of biphenyl core are synthesized for use as host materials for solution‐processible phosphorescent organic light‐emitting diodes (PHOLEDs). In comparison with the traditional small molecular host 4,4′‐N,N′‐dicarbazolebiphenyl (CBP…
Excitation of surface plasmons supported by doped graphene sheets at terahertz frequencies is investigated numerically. To alleviate the momentum mismatch between the highly confined plasmon modes and the incident radiation, it is proposed to increase the surface conductivity of graphene through high doping levels or…
In this work, we have developed a new fabrication method for nanoparticle (NP) assemblies for Li-ion battery electrodes that require no additional support or conductive materials such as polymeric binders or carbon black. By eliminating these additives, we are able to improve the battery capacity/weight ratio. The NP…