Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
α-Li 5 AlO 4 was synthesized using a solid-state reaction, and then different water sorption experiments were performed using N 2 and CO 2 as carrier gases. When the N 2 –H 2 O flow gas was used, α-Li 5 AlO 4 showed a water vapor sorption because of two different processes: superficial hydration and hydroxylation. How…
Abstract A new model of the L–H transition in tokamaks is proposed, based on the criterion that the transition occurs when plasma turbulence and shear Alfvén waves compete in the vicinity of the last-closed flux surface. The model is used to predict the scaling of the H-mode access power, P L–H, with magnetic and plas…
Polyphenylene sulfide (PPS) composite coatings reinforced by graphene were prepared through a spraying method. Wear performance of the composite coatings were evaluated using a block-on-ring test rig, and the results showed that the wear life of the composite coatings were over seven times higher than that of a pure P…
Inspired from biological systems, small synthetic organic molecules expressing the hydrogen bonding arrays of the DNA bases guanine and cytosine were prepared, and their self-assembly into rosette nanotubes (RNTs) was investigated. Due to their unique biological, physicochemical, and mechanical properties, RNTs could…
Abstract The compatibility of styrene‐block‐butadiene‐block‐styrene (SBS) triblockcopolymer in epoxy resin is increased by the epoxidation of butadiene segment, using hydrogen peroxide in the presence of an in situ prepared catalyst in water/dichloroethane biphasic system. Highly epoxidized SBS (epoxy content SBS >26…
A series of hierarchically multimodal (micro-, meso-/macro-) porous carbon monoliths with tunable crystallinity and architecture have been designedly prepared through a simple and effective gelation through a dual phase separation process and subsequent pyrolysis. Because of the magnificent structural characteristics,…
Two kinds of Al/Zr (Al(1%wtSi)/Zr and Al(Pure)/Zr) multilayers for extreme ultraviolet (EUV) optics were deposited on fluorine doped tin oxide coated glass by using direct-current magnetron sputtering technology. The comparison of the two systems shows that the Al(1%wtSi)/Zr multilayers have the lowest interfacial rou…
Coatings derived from surface active block copolymers (SABCs) having a combination of hydrophobic aliphatic (linear hydrocarbon or propylene oxide-derived groups) and hydrophilic poly(ethlyene glycol) (PEG) side chains have been developed. The coatings demonstrate superior performance against protein adsorption as wel…
Several heavy metal ions (HMIs), such as Cd(2+), Pb(2+), and Hg(2+), are highly toxic even at very low concentrations. Although a large number of fluoroionphores have been synthesized for HMIs, only a few of them show detection limits that are below the maximum contamination levels in drinking water (usually in the nM…
Titanium and its alloys are the most popular biomaterials replacing hard tissues in implant surgeries. Clinicians are generally pleased by titanium mechanical properties and non-toxicity performances; on the other hand, there have been reported several cases of titanium implantation failure, phenomenon explained somet…
We demonstrate the effect of single-electron tunneling (SET) through a carbon nanotube quantum dot on its nanomechanical motion. We find that the frequency response and the dissipation of the nanoelectromechanical system to SET strongly depends on the electronic environment of the quantum dot, in particular, on the to…
In this paper, we develop a new ionic polymer–metal composite (IPMC) by replacing a typical platinum or gold electrode with a multi-walled carbon nanotube (MWNT)–graphene based electrode. A solvent of MWNT and graphene is formed on both sides of the ionic polymer membranes as electrodes by means of spray coating and b…
Photoelectron angular distributions from both C(60) and C(70) were recorded for low laser intensity femtosecond and picosecond pulses. Rich structure is seen for electron kinetic energies that lie below the photon energy. Strong, broad peaks are observed for photoelectron energies corresponding to single-photon ioniza…
Abstract It is widely recognized that nonradiative quenching of excitons by other excitons and polarons become the dominant decay mechanism of these excitons at high excitation densities. These quenching processes cause the roll‐off in the efficiency of organic light‐emitting devices (OLEDs) and prevent lasing at high…
In vitro human mesenchymal stem cell (hMSC) proliferation and differentiation is dependent on scaffold design parameters and specific culture conditions. In this study, we investigate how scaffold microstructure influences hMSC behavior in a perfusion bioreactor system. Poly-L-lactic acid (PLLA) scaffolds are fabricat…
In the study, a retrieval approach is extended to determine the effective dynamic properties of a finite multilayered acoustic metamaterial based on the theoretical reflection and transmission analysis. The accuracy of the method is verified through a comparison of wave dispersion curve predictions from the homogeneou…
In this paper, Bi(2)O(3) and rare earth (La, Ce)-doped Bi(2)O(3) visible-light-driven photocatalysts were prepared in a Triton X-100/n-hexanol/cyclohexane/water reverse microemulsion. The resulting materials were characterized by X-ray powder diffraction (XRD), transmission electron microscopy (TEM), Brunauer-Emmett-T…
The new generation of medical implants made by titanium is functionalized with different coatings to improve their bioactivity and reduce a risk of infection. This article describes how these goals can be achieved via deposition of silver nanoparticles and calcium phosphate coating. TiO(2) nanotubes were grown on a Ti…
Abstract Although smouldering ignition of upholstery items remains a leading cause of residential fire deaths, relatively little research is conducted on the topic. An experimental investigation of the effect of sample size on the ignition and spread of smouldering and flaming in polyurethane foam under natural flow c…
PURPOSE: Nanoparticle relaxation time measurements have many applications including characterizing molecular binding, viscosity, heating, and local matrix stiffness. The methods capable of in vivo application are extremely limited. The hypothesis investigated by the authors was that the relaxation time could be measur…