Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
In this paper, we investigate the magnetic and martensitic transformation properties of Cu doping partial Ni in Ni50Mn36In14 alloy. It is found that the critical temperature of the martensitic transformation decreases with Cu concentration x in Ni50-xCuxMn36In14 increases. While Cu concentration is less than 5% at., t…
The HTR code package (HCP) is a new code system, which couples a variety of stand-alone codes for the simulation of different aspects of HTR. HCP will allow the steady-state and transient operating conditions of a 3D reactor core to be simulated including new features such as spatially resolved fission product release…
According to the full-potential linearized augmented plane wave method, we calculate the optical properties of In-doped superlattices ZnO. The results reveal that the Fermi energy level enters into the conduction band after doping In. Dielectric function, absorption, refractive index, reflectivity are found to each ha…
\n\t\t\t\t\tGraphene oxide (GO) offers great potential as nanoscale reinforcement for cementitious material. In this work, the rheological behaviours of the GO-cement composite were investigated for the first time. It was found that the workability of cement paste (w/c=0.5) is significantly decreased with the addition…
The combustion characteristics and kinetic parameters of thermal-treated sludge, coal, and sludge/coal blends were investigated, and the corresponding results are given as follows: In the case of the differential thermogravimetric (DTG) characteristics below 300 C, two peaks were observed, and therefore, over 300 C, o…
Two dissimilar control strategies for extracting reference currents for shunt active power filters have been evaluated and their performances have been compared under various non linear loads. Comparison of the compensation ability of different control strategies based on THD and speed will be done and suggestions wil…
Generalized perturbation theory (GPT) has been widely applied to sensitivity analysis of engineering systems models for decades. It is proven to be an efficient tool to calculate sensitivities in various applications such as uncertainty quantification, adaptive simulation and design optimization [1-3]. GPT is computat…
В термоядерных установках металлические поверхности, обращённые к плазме, подвергаются воздействию импульсов мощных плазменных потоков при срывах плазмы и при краевых неустойчивостях — ЭЛМах. При этом возможны разные механизмы эрозии металла. Предложена модель образования волнообразной поверхности расплавленного с лоя…
.. 1 ,
A Scalable hierarchical architecture based Code-Division Multiple Access (CDMA) is proposed for high performance Network-on-Chip (NoC). This hierarchical architecture provides the integration of a large number of IPs in a single on-chip system. The network encoding and decoding schemes for CDMA transmission are provid…
The author suggests new parameters for determining anisotropic Poisson’s ratios σ of cubic crystals representing combinations of squared ratios of longitudinal and transverse elastic waves velocities along crystallographic directions <100> and <110>.
In the present study, a power supply capable of converting a direct current into an alternating current was built. The frequency of oscillation of the output current could be varied from 174.8 kHz to 726.0 kHz by setting a set of capacitors in resonance. To this power supply is attached a 20-turns copper coil in the s…
The solubilities of the system LiCl–Li2SO4–Li2B4O7–H2O at 298.15 K were calculated based on the Pitzer model and its HW extended model. The values of the parameters were derived from literature or through fitting with the solubility data of the respective ternary system in literature. By comparing the experimental val…
Despite decades of study, relatively little is yet understood regarding the molecular-level events that mediate protein-surface interactions. Experimental methods alone are generally too limited to provide the atomistic level of detail that is needed to characterize the molecular interactions that are involved. Molecu…
Solid oxide fuel cells (SOFCs) are of increasing interest as low emission, high efficiency, energy conversion devices for the production of electricity, and in some cases heat, from a wide range of fuels. In general, a porous cermet of nickel/ytrria-stabilized-zirconia (Ni/YSZ) is used as an anode with a dense electro…
The transdermal delivery is an attractive approach for the delivery of therapeutic molecules, which provides a lot of benefits to patients. However, the delivery of high-molecular-weight drugs (especially hydrophilic agents) is problematic because the difficulty in skin penetration of these molecules. In recent years,…
The aim of this work is to study the influence of tea leave waste on the physical properties and vulcanization behavior of natural rubber (NR) compounds. The tea leave waste was modified by methyl methacrylate (MMA) and silane. The characterization of the modified tea leave waste was achieved with ATIR-FTIR and SEM. R…
Gene therapy has gained widespread interest due to its potential for treatment of many genetic diseases. The use of non-viral systems for delivery of nucleic acids are of particular interest as they can be engineered for high biocompatibility, specificity and targeted delivery. Carbohydrate-based non-viral nano-system…
Multifunctional Composites Using Carbon Nanotube Fiber Materials Yi SongComposite materials have high in-plane mechanical properties and are lightweight.Thus laminated composites are widely used in engineering applications.However, interlaminar stresses can arise and lead to premature failure at low in-plane stress le…
"Se analiza la síntesis, caracterización y las propiedades electroquímicas de diferentes electrodos para baterías de ion litio, identificándose los precursores y los métodos de síntesis, resaltando los procesos de los materiales obtenidos en Bolivia, y las propiedades comerciales ofertadas para estos materiales por di…