Materials Literature
按标题、摘要、年份、主题和来源检索公开元数据。结果保留作者、摘要、分类与原始来源链接。
The morphology and chemical composition of the surface of SiO2 that had been implanted with Zn ions of 60keV and annealed in two different atmospheres, i.e., oxygen gas and a vacuum, were compared. In the as-implanted state, the surface mainly consisted of SiO2 with low roughness due to radiation-induced smoothing. A…
Among the many emerging non-volatile memory technologies, chalcogenide (i.e. GeSbTe/GST) based phase change random access memory (PRAM) has shown particular promise. While accurate simulations are required for reducing programming current and enabling higher integration density, many challenges remain for improved sim…
Photoluminescence with the bandwidth of 45nm (1523–1568nm at the level of 3dB) was observed in amorphous Er2O3 films grown on quartz substrate by pulsed laser ablation of erbium oxide stoichiometric target. Optical transmission spectrum has been fitted to Swanepoel formula [J. Phys. E 16, 1214 (1983)] to determine dis…
Strain relaxation in (Ba0.60Sr0.40)TiO3 (BST) thin films on ⟨110⟩ orthorhombic NdGaO3 substrates is investigated by x-ray diffractometry. Pole figure analysis indicates a [010]BST∥[1¯10]NGO and [001]BST∥[001]NGO in-plane and [100]BST∥[100]NGO out-of-plane epitaxial relationship. The residual strains are relaxed at h∼2…
The objective of this study is to obtain experimental failure models governing solder joint failure during drop impact testing of board assemblies. A high-speed bend test was developed to perform displacement-controlled bend test of board assemblies at the high flexing frequencies of drop impact. These test frequencie…
High density well aligned vertical CNT arrays were synthesized by thermal chemical vapor deposition (CVD) method on 1 inch by 1 inch Si substrates with sputtered Ti and Si layers. They were used as a new kind of thermal interface material (TIM) for the thermal management of microelectronic packages and high brightness…
We have measured the thermal conductivity of organic molecular crystals (DMe-DCNQI) 2 Li 1- x Cu x ( x =1 and 0.75) over a wide temperature range between 4 and 250 K. The electronic contribution can be analyzed particularly below ∼80 K. A thermal hysteresis depending on the Cu concentration x has been observed between…
In this paper we propose a multiphysics simulation of Super-Resolution BD ROM disk readout. Local metallization of the thin semiconductive layer deposited on a ROM substrate comprising a monotone sequence of 100 <i>nm</i> pits has been modelized by applying a Drude nonlinearity to the optical properties of the materia…
Grain boundary sliding is often the picture that explains computer simulation results and experiments on plasticity of nanophase materials. Using atomistic computer simulations we perform a detailed study of the effects of high hydrostatic pressure on nanophase Cu plasticity and find that it can be understood in terms…
This paper discusses thin film technology based on barium titanate (BaTiO3)-epoxy polymer nanocomposites. In particular, we highlight recent developments on high capacitance, large area, thin film passives, their integration in PWB substrates and the reliability of the embedded capacitors. A variety of nanocomposite t…
A new form of gold nanobridges has been recently observed in ultrahigh-vacuum experiments, where gold atoms rearrange to build helical nanotubes, akin in some respects to carbon nanotubes. The good reproducibility of these wires and their unexpected stability allow for conductance measurements and make them promising…
The As-doped (Zn0.93Mn0.07)O thin film prepared by As+ ion implantation showed a clear peak of (A0,X) having acceptor binding energy of 181meV. The sample showed high TC ferromagnetism persisting up to 285K. The contribution of magnetization from Mn ion at 280K was determined to be 0.13μB∕Mn. The improved ferromagneti…
The effect of photoexcitation in the charge sector on the magnetization has been studied with subpicosecond optical pump-and-probe measurements in an antiferromagnetic manganite. Magneto-optic Kerr measurements show a steplike increase of magnetic moment followed by a gradual growth. The steplike behavior is ascribed…
Buckling and postbuckling analysis is presented for a double-walled carbon nanotube subjected to axial compression in thermal environments. The analysis is based on a continuum mechanics model in which each tube of a double-walled carbon nanotube is described as an individual orthotropic shell with the presence of van…
Thin films of Ba0.5Sr0.5TiO3 (BST) were deposited on c-plane (0001) sapphire by rf magnetron sputtering and investigated by complementary materials analysis methods. Microwave properties of the films, including tunability and Q factor were measured from 1to20GHz by patterning interdigital capacitors (IDCs) on the film…
The oxygen ion diffusion and phase transition in La2Mo2−xWxO9 (x=0, 0.25, 0.75, 1.0, and 1.4) have been investigated by the internal friction method. In addition to the low-temperature relaxation peak associated with oxygen ion diffusion, an internal friction peak of phase transition type is observed around 350°C in a…
Alkoxy side-chain-flanked diarylsulfonamide serves as a reliable structural motif for constructing macrocyclic aromatic tetrasulfonamides. This 90 degrees structural motif is persistent both in solution and in the solid state, which allows the one-step formation of tetrasulfonamide macrocycles. These macrocycles adopt…
Mn 3 Sn 2 presents two second-order magnetic transitions of ferromagnetic origin at TC1∼262K and TC2∼227K. Both transitions give peaks of similar magnitude (ΔSMmax∼27mJcm−3K−1 for ΔH=5T) in the temperature dependence of the magnetic entropy change yielding an anomalous magnetocaloric response approaching that of a two…
High-energy focused proton beam irradiation has been used to controllably blueshift the resonant wavelength of porous silicon microcavities in heavily doped p-type wafers. Irradiation results in an increased resistivity, hence a locally reduced rate of anodization. Irradiated regions are consequently thinner and of a…
We report on the synthesis of La0.7Sr0.3MnO3 (LSMO) nanoparticles having perovskite structure and particle size of the order of 30nm. The process involves citrate-gel synthesis, size filtering, and surface coating with a shell of octadecyl amine (ODA) using electrostatic interaction-assisted novel chemical route. Magn…